Eago TB108 User Manual

Screw the flush valve tight, and

make sure the fixture block and seal

Adjust the angle of the flush valve,

make sure the flapper is easy to

washer attach on the tank wall. Put

the flapper on the flush valve .

open, and the chain is not blocked.

Enter the nut on the handle and tighten.

Install the rod into the tank handle

hole.

2.The installation of flush valve

Refill tube

Flush valve

Screw the flush valve tight, and

make sure the fixture block and seal

washer attach on the tank wall. Put

the flapper on the flush valve .

3.Installation of push button

Nut

Washer

Connect Rod

Loose the nut clockwise take away

the nut and the washer from the rod.

Do not use an in-tank type bowl cleaner in your toilet. In-tank cleaners containing chlorine(calcium

hypochlorite)

can seriously damage fittings in the tank. We shall not be responsible for any tank fitting damage caused

by the

WARNING:

Adjustin

use of cleaners containing chlorine(calcium hypochlorite).

Refill nipple

Triangle washer

We will not be liable for damages due to improper handling or installation, abuse, or alteration of the

product. We disclaims any responsibility for incidental or consequential damages.

Washer

Locknut

Inner float

Outer float

Attention: If the product is different fromthe drawing , Please take the object as right.

Unscrew the locknut and

washer.Position the fill valve into

the tank,then screw the washer

and locknut.

562323

05-A1

Please show the manual to final customer.

Installation Manual of Tank TrimInstallation Manual of Tank Trim

General DrawingGeneral Drawing

Fill water valve

Fill water washer

Plastic filter

Connect Water supply Tube

1. Installation of fill valve

Installation

Fixed ring

Tamperproof

Upper tube

Lower tube

Pull the adjusting rod,and raise

or lower the flxed ring to the

desired water level.

Take off the tamper proof,and

adjust the beight by screwing the

upper and lower tube.Then fix the

tamper proof.