Eagle Signal DX100 Catalog Page

EAGLE SIGNAL brand

Electronic Timers

DX100 Time/Count Totalizer

Solid state time/count totalizer... housed in a 1/8 DIN case

E L

The DX100 is a solid state time/count totalizer. The unit is housed in a

1/8 DIN molded NORYL

inch high, 4 1/2 digit liquid crystal display.

■ Annunciators on the front panel indicate time/count operating mode

and time range

■ Six time ranges from 1999.9 seconds to 19999 hours and a count

range of 19999 counts

■ Surface mounted using standard square base relay socket

■ Fixed or plug-in panel mounting accessories available

OPERATION

Timing is referenced to the service line frequency. The line frequency is counted and internal divider networks determine one of six available time ranges.

Two count modes are available and determined by external wiring. Mode 1: Line voltage is applied to the count input. The count is registered when the line voltage is removed from the count input (trailing edge). Mode 2: Contact closure across the internal count circuit registers a count (leading edge).

All units have remote reset capability through external wiring.

NOTE: The cable from the totalizer to the remote reset switch must be a twisted pair with a maximum length of 5 feet.

The 02 option features a manual reset push-button on the front of the unit in addition to the remote reset capability.

The DX100 totalizer has an internal, replaceable battery. The charge on the battery is maintained at a constant level by a trickle charge circuit. A fully charged battery will maintain memory and readout for a minimum of 650 hours with power disconnected. It is recommended that the battery be replaced every two years. Initial slow response of the LCD readout indicates a low battery charge. To charge battery to full capability, apply line voltage to the unit for 48 hours.

case. Time/count totals are displayed by 0.5

RECOGNIZED

SPECIFICATIONS

Time/Count Ranges:

Sym.

00 01 02 03

Operating Voltage/Frequency:

120 VAC, 60 Hz (Can be field modified for 50 Hz operation)

Repeatability: Timing is based on service line frequency Count Accuracy: 100% Count Speed:

2500 per min. with voltage application: 8 MS "ON" 16 MS "OFF" 5000 per min. with switch closure: 4 MS "ON" 8 MS "OFF"

Reset Time: 10 ms Cycle Progress: 4 1/2 digit liquid crystal display

.5 inch high (12.7 mm)

Burden: 120 VAC, 1.2 Watts

120 VDC, 1.2 Watts (counter only)

Current Required to Energize Count Line: 16.4 Microamperes Power Interruption: Line voltage interruptions will not reset timer or

counter. Battery life is a minimum of 2 years.

Operating Temperature: +32˚ to +140˚F (0˚ to +60˚C) Transient Voltage Immunity: Unaffected by 50 microseconds, 600 V peak

transients superimposed on the line input

Vibration: Unit function is unaffected by 2.5

tude in both directions of three perpendicular mounting axes imposed from 20 to 900 Hz

Agency Approvals: UL Recognition E96337 Replacement Battery: PBB9

Range

19999 Cts.

1999.9 Sec. 19999 Sec.

1999.9 Min.

Sym.

04 05 06 07

Range

19999 Min.

1999.9 Hr. 19999 Hr.

Factory Programmed

G sinusoidal vibration magni-

5.50

DANAHER INDUSTRIAL CONTROLS