Eagle Group 313035 Assembly Instructions Manual
PART #313035
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING CARRIER FOR ANY DAMAGE.
YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED
Stainless Steel Worktable with
Adjustable Undershelf
ASSEMBLY INSTRUCTIONS
CAUTION
SAVE YOUR BOX AND ALL PACKING MATERIALS.
IMPROPERLY PACKED.
gusset
Hardware:
set screw
Hardware is located in
plastic bag with brightly colored
“HARDWARE ATTACHED” tape.
Tool required:
• 5/32˝ allen wrench
Step 1 - While on its side, mount undershelf to legs at
desired height. Seat one leg at a time.
• Secure legs to undershelf with set screw (using 5/32˝ allen wrench).
• Each leg must be at the same height or shelf collars could fail.
NOTE: Undershelf must be level. Use care not to overtighten
undershelf set screws or failure will occur. Recommended height
from the floor to the top of undershelf is 10˝.
undershelf
(UNDERSIDE VIEW)
undershelf
tabletop
leg
adjustable foot
Mark desired height
on each leg with magic
marker or grease pencil
leg
set
screw
Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group. ©2012 by the Eagle Group
leg
undershelf
undershelf joined with legs
(continued on next page)
EG9804 Revised 09/12
• 100 Industrial Boulevard, Clayton, Delaware 19938-9905 U.S.A. • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
Stainless Steel Worktable with
Adjustable Undershelf
ASSEMBLY INSTRUCTIONS
If table includes overshelf, attach
overshelf to tabletop NOW while
table is on its side…
… as some mounting bolts
may require access through
gusset/channel assemblies
and into bottom of overshelf
posts.
mounting
bolts
gusset/channel
assembly
tabletop
overshelf
overshelf
posts
Step 2 - Stand table upright and mount tabletop.
• Place tabletop onto top of legs.
• Insert each leg into each tabletop gusset.
• With 5/32˝ allen wrench, tighten set screw on each gusset.
set screw
Step 3 - Level unit.
The leveling feet allow approximately 1˝ adjustment.
leg
leveling
foot
(UNDERSIDE
Assembly is complete.
2
gusset
VIEW)
(End)
Loading...