Eagle PPP-13 INSTALLATION INSTRUCTIONS

Pub. 988-0147-601

Gimbal knob

PPP-13

Portable Power Pack

Installation Instructions

This power pack is designed for use with the following products: Eagle
FishEasy 2, FishEasy 2 T, FishEasy 2 Portable and TriFinder 2.

The PPP-13 package includes the power pack, battery adapter and a
portable transducer. Batteries are not included. The power pack has a
storage compartment for the portable transducer. The pack can be used
with eight "D" cell alkaline batteries or an optional sealed, rechargeable
battery.

The portable power pack expands the uses for your Lowrance or Eagle
sonar. You can use your sonar on your boat or take it to the dock, on a float
tube, on an ice fishing trip or use it as a second sonar in a friend's boat.

INSTALLATION

Recommended tools for installation include a slotted screw driver and
two adjustable wrenches. The following figure shows the proper
arrangement for the washers.

Plastic washer

Rubber washer



Gimbal bracket

Sonar unit

For a secure portable mount, attach the unit to the portable power

pack's gimbal bracket using the supplied gimbal knobs and washers as

shown above.

1

INSTALLING THE BATTERIES

Release the latch on the front of the battery case. Open the
compartment and install either an optional rechargeable battery or
eight "D" cell batteries into the adapter. For the longest life, we
recommend you use alkaline batteries. After installing the batteries,
close the case and plug the power cable on the battery case into the
sonar unit.

Turn the sonar unit on. If it doesn't work, make certain the battery
terminals are making good contact against the battery contacts. Also
check the wiring connections on the D-cell battery adapter. The red
wire on the power cable should be attached to the red wire on the D-cell
battery adapter and the power cable's black wire should be connected to
the black wire on the D-cell battery adapter.

If it still doesn't work, check the battery voltage. Most of the complaints
we receive about portable units result from stale batteries. Make
certain the ones you buy are fresh. Always remove batteries from the
battery compartment before storing the unit as dead batteries can leak
and corrode the contacts.

"D" cell battery

Install batteries in power case battery adapter.

2