Eagle PT-W, PD-W, PD-WBK, PD-N, PD-NBK INSTALLATION MANUAL

PT-W

PT-W, PD-W, PD-WBK,

PD-N and PD-NBK

TRANSDUCERS

INSTALLATION MANUAL

PD-N and

PD-WBK

PD-W and

PD-WBK

When the transducer is mounted on the outside of the hull, periodi-

cally wash the transducer’s face with soap and water to remove any

oil film that may collect. Oil and dirt on the face will reduce the

sensitivity or may even prevent operation.

NOTICE

Copyright Copyright

Copyright

©©

©

1995, 1996 Lowrance Electronics, Inc. 1995, 1996 Lowrance Electronics, Inc.

1995, 1996 Lowrance Electronics, Inc.

1

PT-W INSTALLATION INSTRUCTIONS ONLY

GOOD

MOUNTING

LOCATIONS

The PT-W is a wide cone angle (20 degree) transducer designed to be

used with portable sonar units.

Assemble the transducer and bracket as shown below. Press the

rubber grommet into the hole in the top of the bracket. Tie one end of

the lanyard through this hole.

To use the PT-W, choose an area on the transom that is free from air

bubbles when the boat is moving. Although this is not a high speed

transducer, it will operate when the boat is moving faster than trolling

speeds. It is important to mount the transducer in an area that is free

from air bubbles, since they cause interference on the sonar's display.

Once a good location is found, clean the area before attaching the

suction cup. Moisen the suction cup and press it firmly onto the hull.

The suction cup should be mounted just above the bottom edge of the

hull. This allows the transducer a good chance to be in smooth water at

all times.

Tie the lanyard to the boat. This will prevent the loss of the transducer if

the suction cup comes loose. Route the transducer cable to the sonar

unit.