User Manual
Model: ET-AR516R-BK
2.1 Soundstage Speakers with Dual Subwoofers and Remote
Manual del usuario
Modelo: ET-AR516R-BK
Parlantes 2.1 con subwoofer y control remote
1. Package Contents 3. Product Overview
2. Safety Instructions
1. ET-AR516R-BK speaker system
2. Wireless remote with battery
3. User manual
4. 3.5mm to RCA audio cable
1. Power switch
Turn power on or o
2. Volume +/-
Turn volume up or down
3. Bass +/-
Turn bass up or down
4. Power LED
Power on indicator
5. Power cord
Connect to 120V AC outlet
6. Audio input
Connect to your audio device (TV,
DVD, MP3, etc) via RCA cable
7. Audio output
Connect to left & right satellite speakers
via RCA cable
8. Tre +/-
Turn treble up or down
9. Bass +/-
Turn bass up or downl
10. Mast +/-
Turn volume up or down
11. Reset
Set volume, bass, treble to factory
default
12. Mute
Turn volume on or o
13. Battery
Battery type CR2025
TRE+
TRE-
BASS+
BASS-
MAST+
MUTE
MUTE
ST-BY
MAST-
Manual
Caution: Electric Shock Hazard
When using this electronic appliance, basic precautions should always be followed to reduce
the risk of re, electrical shock and injury to persons, including the following:
1. Do not use this product near water i.e.
bath tub or swimming pool.
2. Unplug from AC outlet when not in use
and before cleaning.
3. Close supervision is necessary when
used near children.
4. Clean only with dry cloth.
5. Do not attempt to repair the product on
your own. It contains no user serviceable parts.
6. Do not dispose of batteries in re. They
may explode. Check local codes for
battery disposal instructions.
TRE+
TRE-
BASS+
BASS-
MAST+
MUTE
MUTE
ST-BY
MAST-
INPUT
LRL
R
OUTPUT
1
7
8
9
11
10
12
4
32 56
13
INPUT
LRL
R
OUTPUT
4. Product Setup
Speaker
1. Connect your music device to Audio Input
2. Connect the satellites to Audio Output.
3. Connect the power cord to 120V AC
outlet.
4. Turn on the power switch.
5. Slowly increase volume until reaching a
comfortable level. Adjust treble or bass as
needed.
Remote control
1. Remove the plastic tab from the battery
compartment.
2. Point the remote control to the
subwoofer’s front panel.
3. Press one button at a time to make
adjustments.
1
2 34
5. Optimum Settings
1. For best reception, always point the remote
control at the subwoofer. The remote control’s
eective range is approximately 10 feet.
2. For best tonal delity, we recommend setting
your audio source to line level output and use
the speaker to control overall volume level.
3. This speaker system is most ecient when
the volume level is set between 30% to 80%.
You get highest sound quality and minimum
distortion within these volume levels.
4. Place the satellite speakers at least 16 inches
from each other. This enhances stereo sound
eect and perceived sound eld.
5. Provide ample space around the subwoofer
unit. It needs enough room to move massive
amount of air! To further enhance lower
frequencies, place the subwoofer unit near
walls.
6. Specication
• Total RMS Power: 50 Watts
- Satellites: 10 Watts RMS x 2 (into 4 ohms,
@<=1% THD)
- Subwoofer: 30 Watts RMS x 1 (into 4 ohms,
@<=1% THD)
• Total Peak Power: 100 Watts
• Frequency Response: 40Hz to 18kHz
• Drivers:
- Satellites: 3-inch midrange and 1-inch
tweeter with wooden enclosure
- Subwoofer: Dual 5-inch driver with wooden
enclosure
• Speaker Dimension:
- Satellites: 4.1 x 4.1 x 7.5 inches
- Subwoofer: 13.9 x 10.7 x 7.5 inches
Loading...