Eagle Arion ET-AR510LR-BK User Manual

®

User Manual

Model: ET-AR510LR-BK

2.1 Soundstage Speakers with Subwoofer

TRE+

TRE-

BASS+

BASS-

MAST+

MUTE

MUTE

ST-BY

MAST-

AUDIO INPUT

AUDIO OUTPUT

POWER SOURCE

1. Package Contents 3. Product Overview

2. Safety Instructions

1. Status LED

Displays Volume, Treble, Bass, EQ

2. Menu

Switches functions: Volume, Treble or

Bass

3. Up arrow

Increases volume or adjusts selected

menu function

4. Down arrow

Decrease volume or adjusts selected

menu function

5. Left arrow

Selects previous menu function

6. Right arrow

Selects next menu function

7. Power cord

Connects to 110V AC outlet

8. Audio input 1

For CD/MP3

9. Audio Input2

RCA Input

10. Power switch

Turns speakers on/o

11. Mast+

Increases master volume

12. Mast-

Decreases master volume

13. Bass+

Increases bass level

14. Bass-

Decreases bass level

15. Tre+

Increases treble level

16. Tre-

Decreases treble level

17. Reset

Resets Bass and Treble settings to

factory default

18. Mute

Turns on/o master volume

19. Battery compartment

Insert Battery with lettering facing top

TRE+

TRE-

BASS+

BASS-

MAST+

MUTE

MUTE

ST-BY

MAST-

Manual

Caution: Electric Shock Hazard
When using this electronic appliance, basic precautions should always be followed to reduce
the risk of re, electrical shock and injury to persons, including the following:

1

7

9

10

16

13

12

17

15

14

11

18

19

8

4

3

2

5

6

1. Do not use this product near water i.e.
bath tub or swimming pool.

2. Unplug from AC outlet when not in use
and before cleaning.

3. Close supervision is necessary when
used near children.

4. Clean only with dry cloth.

5. Do not attempt to repair the product on
your own. It contains no user service­able parts.

6. Do not dispose of batteries in re. They
may explode. Check local codes for
battery disposal instructions.

1. ET-AR510LR-BK speaker system

2. Wireless remote with battery

3. User manual

4. 3.5mm to RCA audio cable

AUDIO INPUT

AUDIO OUTPUT

POWER SOURCE

4. Product Setup

1. Connect the stereo cable to
your music device.

2. Connect the RCA connectors to
the back of the system.

3. Connect the power cord to an
AC outlet.

4. Turn on the power and slowly
increase the volume until reach­ing a comfortable level.

5. Adjust treble or bass as needed.

1

2

3

4

OR

5. Understanding LCD Display

1. Volume

Indicates if the system is being set to

Volume Adjustment Mode

2. Treble Adjustment Indicator

Indicates if the system is being set to
Treble Adjustment Mode

3. Volume Indicator

Indicates if the system is being set to

Volume Adjustment Mode

4. Subwoofer Indicator

Indicates Subwoofer is in used

5. Bass Adjustment Indicator

Indicates if the system is being set to
Bass Adjustment Mode

1

2

3

4

5

TRE+

TRE-

BASS+

BASS-

MAST+

MUTE

MUTE

ST-BY

MAST-

TRE+

TRE-

BASS+

BASS-

MAST+

MUTE

MUTE

ST-BY

MAST-

TRE+

TRE-

BASS+

BASS-

MAST+

MUTE

MUTE

ST-BY

MAST-

7. Using the wireless Remote

Adjusting Volume/Mute using Remote Control

1. Press Mast+ button to increase volume level and Mast- button to decrease volume level.

2. Press Mute to turn on/o master volume. Press again to resume previous volume level.

Adjusting Treble/Bass using Remote Control

1. Press Tre+ button to increase bass level and Tre- button to decrease bass level.

2. Press Bass+ button to increase volume level and Bass- button to decrease volume level.

Resetting EQ Levels using Remote Control

1. Press Reset button to reset all EQ levels to factory default.

Adjusting Volume/Mute using Remote Control Adjusting Treble/Bass using Remote Control Resetting EQ Levels using Remote Control

6. Using Front Panel Controls

1. The LCD area displays your current selection.

2. Press the Menu button until you have selected your desired
function. Press the Up or Down arrow to change the setting

(Volume • Bass • Treble • Equalizer)

9. Specication8. Optimum Settings

1. For best reception, always point the remote control at the LCD display area. The re­mote control’s eective range is approximately 10ft.

2. For best tonal delity, we recommend setting your audio source to line level output and
use the speaker to control overall volume level.

3. For best tonal delity, we recommend using the default EQ levels so you hear the music
at exactly the same way it was recorded. The easiest way to do this is by pressing the
Reset button located on the remote control.

4. This speaker system is most ecient when the volume level is set between 30% to 80%.
You get highest sound quality and minimum distortion within these volume levels.

5. Place the satellite speakers at least 16 inches from each other. This enhances stereo
sound eect and perceived sound eld.

6. Provide ample space around the subwoofer unit. It needs enough room to move massive
amount of air! To further enhance lower frequencies, place the subwoofer unit near walls.

• Total RMS Power: 40 Watts

-Satellites: 10 Watts RMS x 2
(into 4 ohms, @ <=1% THD)

-Subwoofer: 20 Watts RMS x 1
(into 4 ohms, @ <=1% THD)

• Total Peak Power: 80 Watts

• Frequency Response: 20Hz to 20kHz

• Drivers:

-Satellites: Dual 3-inch midrange and
1-inch tweeter with wood enclosure

-Subwoofer: 5.25-inch drivers with wood enclosure

• Speaker Dimension
(H x W x D):

-Satellites: 4.33” x 9.65” x 4.77”

-Subwoofer: 6.7” x 11.03” x 10.25”

12. Contacting Us

If you have questions about Eagle Tech products, rebates or RMA, please visit www.eagletechusa.com/sup­port.asp and submit your request to the appropriate department:

Customer Service obtain technical support

RMA obtain new RMA number to return defective item(s)

Rebate check status of your mail-in rebate(s)

Eagle Tech Computers, Inc.
18539 East Gale Avenue
City of Industry, CA 91748
USA
www.eagletechusa.com
Phone: [phone]
Fax: [phone]

© 2010 Eagle Tech Computers, Inc. Reproduction in whole or in part is prohibited. All rights reserved.
Eagle Arion ® is a registered trademark of Eagle Tech Computers, Inc. Other trademarks and trade names
are those of their respective owners.

10. Regulatory Compliance

FCC Class B Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful in­terference in a residential installation. However, there is no guarantee that interference will not occur in a
particular installation.

CE Compliance for Europe
This equipment has been tested and found to comply with the limits for European Council Directive on the
approximation of the law of the member states relating to electromagnetic compatibility (89/336/EEC) ac­cording to EN55022 Class B.

11. Limited Warranty

Eagle Tech warrants that the product, in the course of its normal use, will be free from defects in material
and workmanship for a period of one (1) year. This limited warranty period shall commence on the pur­chase date appearing on your purchase receipt. Eagle Tech shall have no liability for any product returned
if Eagle Tech determines that the product was not purchased from authorized retailers, that the asserted
defect a) is not present, b) cannot reasonably be rectied because of damage occurring before Eagle Tech
receives the Product, or c) is attributable to misuse, improper installation, alteration (including removing
or obliterating labels and opening or removing parts. The foregoing warranty shall extend to repaired or
replaced products for the remaining of the applicable period of the original warranty or ninety (90) days
from the date of shipment of a repaired or replaced product, whichever is longer.

®

Eagle Tech Computers, Inc.

www.eagletechusa.com
Phone: [phone]
Fax: [phone]