Page 1
Product Contents
Controls Diagram
Controls
Focal Length Adjustment
Eachine EV100
NEW 5.8G FPV Goggles
White/Black
User Manuals
Eachine EV100
Goggles *1
Battery*1
Antenna*2
USB data cable*1
Lenswiping cloth*1
User Manuals*1
Channel/Band Selection
Turn on/off OSD
USB in
Eachine EV100
NEW 5.8G FPV Goggles
White/Black
User Manuals
3.5mm Headphone jack
Power supply
3.5mm AV in/out
Focal length adjustment
1
Mode/Brightness/Contrast
2
RP-SMA* 2
To check battery level
USB charging port
SMA *2
IPD adjustment
fan on/off
Mode/Brightness/Contrast control
Mode : a.Debug mode: Press "mode" button and
power on, enter debug mode (5300MHz).
b.Racing mode:Long press "mode" button until first beep
to switch mode from 4 pilots/6 pilots/8 pilots. For example:
4 pilots/6 pilots/8 pilots/exit racing mode switching circularly.
c.Auto search: Long press "mode" button until second beep
to enter auto search.
d.Turn on/off RX: Long press "mode" button until third beep
to enter AV IN (RX OFF).
Auto search display
Brightness: Pressing forward/back increases/decreases
display brightness.( )32 level contrast for the LCD display, default level 28
Contrast: Pressing left/right decreases/increases
display contrast.( )32 level contrast for the LCD display, default level 28
Channel/Band select
Channel: short Press channel up/down buttons will cause
the channel to incrementallyincrease/decrease from
channels 1 to 8 (refer to frequency table).
Band : Press channel up/down buttons 3s will cause
the band to incrementallyincrease/decrease from band
A to H (refer to frequency table).
Turn on/off OSD: Press channel up/down buttons
simultaneously to turn on/off OSD.
Low battery warning: Buzzer warning if input voltage
drops below 6.8V.
Turn on/off fan
72
1
AV IN display
AV IN
3
Adjustable focal length is perfect for myope under 400
degree and hyperope under 100 degree.
Thumbwheel is used to adjust focal length.
(+) means to increase diopter, (-) means to
decrease diopter.
IPD Adjustment
Independent control for both sides,adjust the range
of 58 ~ 68mm.
Slider is switch to adjust IPD. (+) means to
increase IPD,(-)means to decrease IPD.
4
AV In/Out
3.5mm AV Connector
AV inp ut & o ut pu t
Suppo rt e xt er na l HD MI t o AV inp ut
Suppo rt e xt er na l DV R.
Groun d Video AudR AuL
USB In
▪For firmware upgrading.
▪Alternative power supply.
If multiple power sources are supplied at same time
(Like: power Bank and head strap battery)the goggles
will draw power from the highest voltage.
Mode
In this mode, the best results can be achieved
by using the supporting vtx.
Racing Mode
3 Racing Mode: 4/6/8 pilots
60-80MHz interval between adjacent channels
greatly decrease interference.
Debug Mode
Press "mode" button first and then powering on
goggles, enter debug mode (5300MHz). Requires
a corresponding vtx which support pitmode and
extra frequency 5300MHz.
5
Battery
Li-Po BATTERY PACK
7.4V 1000mAh(7.4Wh) with LED indicator
(On e ch ar gi ng i nd icat or l ig ht , on e
pow er -c he ck in g bu tt on a nd f ou r
pow er i nd ic at or l ig ht s)
It ca n si mu lt an eo us ly p ow er t he e xt er na l DV R.
Made in china
Battery charging
Charge max rate of 1C(DC connector)
USB charging with approved adapter
( USB:5V==1.5A or 2A)
It is not recommended to charge the battery
via PC USB, since the insufficient current will
damagethe battery.
WARNING
Do not open the battery case
Never leave batteries near fire or
high temperatures
Battery may balloon or catch fire if faulty
or improperly charged
Never leave a charging battery unattended
Do not use if signs of failure
6
Detachable Patch
Snap joint asse mb lies allows easy
replacement and maintenance
Replaceable sponge
Patch
Velcro
Sponge
Flannel
Using Velcro as a bridge, sponge and flannel
can be easily replaced, and Velcro can be
used fo r a lo ng tim e.
7
Product s pecific ations
FOV:
Type:
IPD:
Focal length :
Display:
User Controls:
Weight(not included battery): 180g
Under 400 degree of myopia and
Hyperopia 100 degree (adjustable)
Resolution : 720*540
NTCS/PAL auto selecting
7.4V,1000mAh Li-po battery with
Battery:
LED indicator
Can power the external DVR
3.5mm AV in/out port
Interface:
Power in port
3.5mm stereo earphone port
USB in port
Accessories:
-10c°-40c°
Operation temperature :
Frequency:
Sensitivity:
Dimensions:
Packaging:
165*76*30mm
235*120*70mm
Channel/Band selection
Mode selection (debug/racer)
Contrast/ brightness control
Turn on/off RX/fan/OSD
Lens wiping cloth
USB data cable
5.8G RP-SMA male antenna*2
7.4V, 1000mAh Li-po battery with
LED indicator
Plastic optic module
58 to 68 mm (adjustable)
5.8GHZ 5333—5945MHZ
Status des cript io n
8
8 2 °Diagonal
≤-93DB
Band & Freq uency ta ble
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Band
━
Band A
5865
5845
5825
5805
5785
━
Band b
5733
5752
5771
━
5705
Band E
Band F
Band r
Band U
Band o
Band L
Band H
Racing mode frequency
4 pil ots 569 5 5769 58 43 5 91 7
6 pil ots 553 3 5613 57 05 5 78 5 58 65 59 45
8 pil ots 552 8 5582 56 45 5705 5 76 5 58 25 5 885 5 945
5685
━
5740
5760
━
5658
5695
━
5325
5348
━
5474
5492
━
5333
5373
━
5653
5693
5665
5780
5732
5366
5510
5413
5733
5790
5645
5800
5769
5384
5528
5453
5773
5809
5885
5820
5806
5402
5546
5493
5813
5765
5828
5905
5840
5843
5420
5564
5533
5853
OSD display
Regular mode:
Racing mode:
Display values like: Band-r CH1 5658MHz
(refer to frequency table)
Mod e
9
5745
5847
5925
5860
5880
5438
5582
5573
5893
Unit:MHZ
5725
5866
5945
5880
5917
5456
5600
5613
5933
Trouble Shooting
No image, display is completelydark
▪No power supplied. Check power connections.
No image, display is glowingdark grey
▪If using wireless module, ensure RX is working.
If using AV in cable, check video source.▪
Ensure TX is on and camera connections solid▪
Ensure lens cap is removed from camera ▪
Complete white screen
▪LCD driver has failed and needs to be replaced under
warranty. Contact your retailer.
Short range
▪Ensure 5.8Ghz antenna were installed.
10
157G铜版纸⿊⽩正反印刷折页
折叠尺⼨:110*70mm
展开尺⼨:420*110mm
Loading...