Eachine 3D X4 Instruction Manual

EACINE

4-CHANNEL

QUADCOPTER

Product code: EACHINE 3D X4

INSTRUCTION MANUAL

4

.1.1

if

401V-

Orientation mode

1.Main Features

1.

4 motors driven, leading to steady flight and rolling

2.

Easily install and fix

3.

Adopt 6-gyro, one key 3D flip. Easy control, better flight

AGES

1

Rear Rotor
Blade (BLACK)

Rear Rotor
Blade (BLACK)

■

7\

FRONT

Front Rotor
Blade (WHITE)

Front Rotor
Blade (WHITE)

Elevator Trim
(Forward/Backward)

Throttle Trim

•

Throttle Stick + Rudder
(Ascend/Descend
Turn RighVTum Left)

Rudder Trim (Rotation)

video(op

▪

tional feature)

photo{optional feature)

light •

speed adjustment: 1 00%

•

20%



• E

3D flip

key:

click once,
then control Direction
Stick from left, right,
forward to backward

•

Direction Stick
(Elevator+Aileron)

Aileron Trim
(Sideways-Left/Right)

2. Parts of the Quadcopter

3. Parts of the Transmitter

Power switch

2

4. Safety Precautions

1.

Please read these Instructions carefully and follow them when
operating the Quadcopter.

2.

Fly the quadcopter within your line of vision for easier control.

3.

Never fly the quadcopter in crowded areas, near to toward
people or animals, to prevent property damage and/or personal
injury.

4.

Do not attempt to modify the product.

5.

Keep small elements of the product away from small children,
to avoid CHOKING accidents.

6.

Keep at least 1-2 meters distance from the quadcopter when it
is flying, to avoid injury.

7.

Do not dispose the batteries in the heat (fire, electronic heating
device, etc.).

8.

Do not dispose the quadcopter in wet ( rain, moisture, dust, fog
etc.) to avoid the parts malfunction.

9.

Parental guidance is highly recommended.

5. Preparation to Fly

1.

This quadcopter is designed for Outdoor, Indoor flight.
However it is important to note the recommended conditions
and flying environment.
Choose a place with a minimum of potentially hazardous
obstacles.
Recommended minimum flying area: 8m x 8m x 4m

2.

Make sure the batteries of the quadcopter and transmitter are
fully charged.

3.

Turn the transmitter "OFF". Push the Throttle Stick downwards
to the minimum position. Place the transmitter close to the
quadcopter.

4.

Connect the charged Li-PO battery to the PCB. LEDs start to
flicker. Do Not Move the quadcopter after this point. Switch

"ON" the transmitter. The binding process is on.

5.

Check carefully the batteries and motors. Make sure all in
condition.

6.

Recommended condition to Flip: battery voltage at 3.8V-4V.

3