DYTRAN 3023A2 DATA SHEET
.36
[9.1MM]
.36
[9.1MM]
1/4-28 4 PIN
CONNECTOR
.49
[12MM]
4. SENSITIVITY: 10mV/g NOMINAL
3. WEIGHT: 4 GRAMS
2. ARROWS INDICATE ACCELERAT ION
DIRECTION FOR POSITIVE OUTPUT
1. MATERIAL: TITANIUM ALLOY
PIN 4 X-AXIS (1) OUTPUT
PIN3 Z-AXIS
(3) OUTPUT
MOUNTING SURFACE 10-32
MOUNTING HOLE .12 DEEP
MODEL 6200 MOUNTING
STUD PROVIDED
DYTRAN
SCALE
DATE
DRAWN
APPROVED
TITLE
4:1
1/14/2005
R.A.
CHECKED
P.M.L.
OUTLINE/INSTALLATION DRAWING,
MODEL 3023A2
REV
-
PART NO.
MATERIAL
NEXT ASSEMBLY
DATE
-
127-3023A2
-
PIN 1 GND
RETURN COMMON
PIN 2 Y-AXIS
(2) OUTPUT
CHATSWORTH, CAINSTRUMENTS, INC.
ECN
-
USED ON
DWG NO.
127-3023A2
SHEET OF
1
-
1
SPECIFICATIONS, MODEL 3023A2 TRIAXIAL ACCELEROMETER
SPECIFICATIONS VALUE UNITS
PHYSICAL
WEIGHT 4 GRAMS
SIZE (HEIGHT x WIDTH x DEPTH) 0.49 x .36 x .36 INCHES
MOUNTING 10-32 TAPPED HOLE IN BASE
CONNECTOR 4-PIN [1]
MATERIAL, HOUSING/CONNECTOR TITANIUM ALLOY
PERFORMANCE
SENSITIVITY, -10 +15% [2] 10.0 mV/G
RANGE, F.S. (each axis) +/- 500 G
FREQUENCY RESPONSE, -5 / +15%
Axis 1 & 2 1.5 to 5000 Hz
Axis 3 1.5 to 10000 Hz
ELEMENT NATURAL FREQUENCY, NOM. 40 kHz
EQUIVALENT ELECTRICAL NOISE .0095 G, RMS
LINEARITY [3] 1 %F.S.
TRANSVERSE SENSITIVITY, MAX, 5 %
SIGNAL POLARITY POSITIVE FOR MOTION IN DIRECTION OF ARROWS ON HOUSING
ENVIRONMENTAL
MAXIMUM VIBRATION +/- 600 G
MAXIMUM SHOCK 5000 G
TEMPERATURE RANGE -60 to +250 oF
ENVIRONMENTAL SEAL HERMETIC
COEFFICIENT OF THERMAL SENSITIVITY .03 %/oF
ELECTRICAL
SUPPLY CURRENT RANGE, (each axis) [4] 2-to 20 mA
COMPLIANCE (SUPPLY) VOLTAGE RANGE (each axis) +18 to +30 VDC
OUTPUT IMPEDANCE, TYP. 100 OHMS
OUTPUT BIAS VOLTAGE, +7 to +9 VDC
DISCHARGE TIME CONSTANT, NOM. 0.3 SEC
GROUND ISOLATION CASE GROUNDED
[1] Connector mates with Dytran cable assy. Model 6811Axx. (xx = length in feet)
[2] Reference sensitivity measured at 100 Hz, 1 G RMS per ISA RP 37.2
[3] Linearity is % of specified full scale (or any lesser full scale range), zero-based best fit straight line method.
[4] Power only with Dytran LIVM power unit or other Dytran-compatible constant current type power unit. If power
is applied without current limiting protection, the internal amplifier will be immediately destroyed.
Rev C, ECN 7002 8/31/10
2
Loading...