Dynatek DFCH-5 User Manual

Dynatek • 164 S. Valencia St. Glendora CA 91741

www.dynaonline.com 800.928.3962

User Manual

Parts List

FI Controller
Installation Guide
Wire tap
Wire ties
Velcro

®

Strip

Alcohol Swab

2002-2005 Harley Davidson

V-Rod Models

Part Number DFCH-5

2801190 REV. 8-11-05

Congratulations on your purchase of this Dynatek product.

Please take a moment to read these instructions completely before

installing the FI controller. The installation will only take a few minutes,

but proper setup for your specific bike will take longer

Tools required: 5mm Hex wrench, 10mm
socket, pliers

Lift the seat. Remove the airbox cover.
Unplug the sensor at the front of the airbox.
Undo the 8 clamps on the airbox, and remove
the lid. There are 3 clamps on each side, 1 at
the front and 1 at the rear. Remove the air
filter. Using the 5mm Hex wrench, remove the
3 bolts at the base of both of the air horns
inside the airbox.

Use the pliers to loosen the clamp on the
breather hose that goes from the airbox to
the rear cylinder head. Remove the breather
hose. Lift and remove the airbox.

Place FI Controller (FIC) on battery. Route
wiring harness down left side of bike. On the
FIC harness, locate the black wire with with
the ring terminal. This needs to be grounded
to the bolt that is on the front cylinder head.
Use a wire tie to secure the FIC harness to
the stock wiring harness.

STEP 1

STEP 3

STEP 2

Installation

Part# DFCH-5 2

STEP 3

STEP 2

STEP 1

Ground

Tie