Dynamic Cooking Systems DCS-DRH-48N, DEL REY Installation Manual

DEL REY HEATER REMOTE CONTROL KIT

INSTALLATION INSTRUCTIONS

IMPORTANT!

Read all instructions before you begin. Do not jump ahead or skip any step.

CAUTION!

Some parts may have sharp edges; care must be taken when handling the various components
to avoid injury. Please read safety information provided in these instructions before beginning
assembly. Be sure to have a qualified technician install and ground this appliance before using.

CONTENTS INCLUDED:

The package contains a weather-proof receiver assembly, wire nuts, a transmitter remote control and
installation sheet (Fig. 01 & 02).

Fig. 02

Fig. 03

Fig. 01

Contents Qty.

1

6

1

1

TOOLS REQUIRED:

Receiver Assembly

Wire Nuts

Transmitter

Transmitter Receiver,

inside Receiver Assembly

Instruction

Eye Goggles

Work Gloves

Power Screwdriver or

Variable Speed Drill with

Phillips -tip #2 Attachment

Control

Button

Activation
light

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired
operation.

WARNING

Changes or modifications to this unit not expressly approved by DCS by Fisher & Paykel could
void the user’s authority to operate the equipment. DCS by Fisher & Paykel will not be held liable
or responsible for any misuse or application of this product other than for its intended use.

SPECIFICATIONS

RANGE: Up to 100 feet
INPUT: 120 VAC 60 Hz
MAXIMUM LOAD: 300W
BATTERY (TRANSMITTER): 12-volt alkaline battery

(type 23AE, see Fig. 04)

ELECTRICAL

This kit contains the 24 VAC, 40 VA transformer and remotely controlled switch that’s needed for proper
operation. If this is an upgrade to an existing installation, discard the transformer that is currently installed
with your heater (DCS DRH-48N). It’s no longer needed. Follow the electrical diagram to connect the heater to
the transformer wires included in this kit and to connect the electrical supply line to the switch receptacle
(Fig. 05~07).

Each remote control box must be electrically grounded and installed in accordance with the local codes or, in
the absence of local codes with the National Electrical Code, ANSI/NFPA 70. Use at least 18 AWG wire up to 50
ft from heater to remote control unit. Use 16 AWG over 50 ft distance. If the original wires supplied should
need replacement, they must be replaced with wiring material having a temperature rating of at least 105°C.

The on-off control of the heater is controlled by the transmitter (Fig. 02). This unit provides 24 VAC power
to your Del Rey built-in patio heater.

NOTE: Aim the transmitter at the box when operating.

Fig. 04

Fig. 07

Black

(Line)

White
(Nut.)

Input 110 VAC

Green

(Grd.)

Green

(Grd.)

NL

Transformer

EXISTING TRANSFORMER CONFIGURATION

REMOTE CONTROLLED CONNECTION

24 VAC Input

115 VAC Power

24 VAC Input

115 VAC Power

24 VAC

24 VAC

Existing transformer is replaced
with the receiver assembly

Weatherproof protective
enclosure

Fig. 05

Fig. 06

Receiver

Pre-wired Pigtail
Interface

Enclosure

Pre-wired 115 VAC

Receptacle

Harness with

Receptacle

24 VAC Transformer

Wire Nuts (

Output
24 VAC wires

RECEPTACLE

N

GG

L

18 CA AWG INPUT

(110 VAC MIN. 60 Hz, 10 Amp)

G

GROUND
CHASSIS

GROUND
CHASSIS

24 VAC

110 VAC

STEP DOWN

TRANSFORMER

18 AWG OUTPUT
(24 VAC MIN.) TO HEATER

REMOTE
SENSOR

9HX9

APPLIANCE

CONTROL

LOCATION

Do not locate this unit or any electrical supply line directly over the heater. Electrical short or fire may occur
due to overheating. Follow the diagram below for appropriate zones for the installation of this unit (Fig. 08).

WARNING

The unit must be mounted outside the shaded areas shown in the diagram below (Fig. 08). The
remote control box must be installed in a location such that it is accessible for servicing.

30° max.

30° tip mount

infrared

pattern

horizontal mount

flue heat 48”

flue

heat 24”

FRONT VIEW SIDE VIEW SIDE VIEW

flue

heat 24”

Fig. 08 Infrared Pattern

BATTERY REPLACEMENT

1. Use 12-volt alkaline battery (type 23AE, see Fig. 04).

2. Open the battery compartment cover, and replace the old battery with a new one.

NOTE: DO NOT dispose of battery in fire. Battery may explode or leak.

TROUBLESHOOTING:

Heater does not come on.

1. Circuit breaker has tripped, power switch is in “OFF” position, or fuse is blown. Check circuit breaker,
power switch, or check and replace fuse if necessary.

2. Signals from remote control are being blocked, or remote is out of range. Check for metal objects
that could block the signal or reposition the remote control.

3. Weak battery in the remote control. Check/replace battery.

4. See troubleshooting guide the came with your heater.

Heater does not turn off.

1. Pushing remote control button too fast.

2. Same as 2~3 above.

TROUBLESHOOTING (CONTINUED):

Manual shutdown (if it becomes necessary to turn off heater without using the remote):

1. Switch the power to “OFF” or,

2. Open the circuit breaker that supplies power to the heater.

3. Wait for flame to extinguish completely before restoring power to the circuit again.

Note: It will be necessary to use the remote to start the heater again after a manual shutdown.

HOW TO OBTAIN SERVICE:

For warranty service, contact DCS Customer Care Center at [phone]. Before you call, please have the
following information ready:

■ Model Number

■ Serial Number

■ Date of installation

■ A brief description of the problem

Your satisfaction is of the utmost importance to us. If a problem cannot be resolved to your satisfaction,
please email us at: [e-mail]

or write:

Fisher & Paykel Appliances, Inc.
Attention: DCS Customer Care
5900 Skylab Road
Huntington Beach, CA 92647

www.dcsappliances.com

Before you call for service:

1. Is the circuit breaker tripped or the fuse blown?

2. Is there a power outage in the area?

3. Replace the battery in the transmitter.

4. Check for any sounds like clicking or humming coming from the remote control unit with power
turned on.

5. Turn off the power supply for 5 minutes and restart.

6. Check heater troubleshooting guide that came with your heater.

LIMITED WARRANTY

When you purchase a new DCS remote control by Fisher & Paykel, you automatically receive a One Year
Limited Warranty covering parts and labor for the entire product, and a Five Year Limited Warranty on all
stainless steel components for servicing within the 48 mainland United States, Hawaii, Washington D.C. and
Canada. In Alaska, the Limited Warranty is the same except that you must pay to ship the Product to the
service shop or for the service technician’s travel to your home. Products for use in Canada must be
purchased through the Canadian distribution channel to ensure regulatory compliance. Surface corrosion and
discoloration is not covered under warranty.

FISHER & PAYKEL UNDERTAKES TO:

Repair without cost to the owner either for material or labor any part of the Product, the serial number of
which appears on the Product, which is found to be defective. In Alaska, you must pay to ship the Product to
the service shop or for the service technician’s travel to your home. If we are unable to repair a defective part
of the Product after a reasonable number of attempts, at our option we may replace the part or the Product,
or we may provide you a full refund of the purchase price of the Product (not including installation or other
charges).

This warranty extends to the original purchaser and any succeeding owner of the Product for products
purchased for ordinary single-family home use. All service under this Limited Warranty shall be provided by
Fisher & Paykel Appliances Inc. or its Authorized Service Agent during normal business hours.

HOW LONG DOES THIS LIMITED WARRANTY LAST?

Our liability under this Limited Warranty for the entire product expires ONE YEAR from the date of purchase
of the Product by the first consumer. Our liability under this Limited Warranty for stainless steel components
(not including surface corrosion and discoloration) expire FIVE YEARS from the date of purchase of the
Product by the first consumer.

Our liability under any implied warranties, including the implied warranty of merchantability (an unwritten
warranty that the Product is fit for ordinary use) also expires ONE YEAR (or such longer period as required by
applicable law) from the date of purchase of the Product by the first consumer. Some states do not allow
limitations on how long an implied warranty lasts, so this limit on implied warranties may not apply to you.

THIS WARRANTY DOES NOT COVER:

A. Service calls that are not related to any defect in the Product. The cost of a service call will be charged if

the problem is not found to be a defect of the Product. For example:

1. Correct faulty installation of the Product.

2. Instruct you how to use the Product.

3. Replace house fuses, reset circuit breakers, correct house wiring or plumbing, or replace light bulbs.

4. Correct fault(s) caused by the user.

5. Change the set-up of the Product.

6. Unauthorized modifications of the Product.

7. Noise or vibration that is considered normal, for example, drain/fan sounds, regeneration noises or
user warning beeps.

8. Correcting damage caused by pests, for example, rats, cockroaches etc.

B. Defects caused by factors other than:

1. Normal domestic use or

2. Use in accordance with the Product’s User Guide.

C. Defects to the Product caused by accident, neglect, misuse, fire, flood or Act of God.

D. The cost of repairs carried out by non-authorized repairers or the cost of correcting such unauthorized

repairs.

E. Travel Fees and associated charges incurred when the product is installed in a location with limited or

restricted access (i.e. airplane flights, ferry charges, isolated geographic areas).

F. Normal recommended maintenance as set forth in the Product’s User Guide.

If you have an installation problem contact your dealer or installer. You are responsible for providing
adequate electrical, exhausting and other connection facilities. We are not responsible for consequential
or incidental damages (the cost of repairing or replacing other property damaged if the Product is
defective or any of your expenses caused if the Product is defective). Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you.

HOW TO GET SERVICE

Please read your User Guide. If you then have any questions about operating the Product, need the name of
your local DCS Authorized Service Agent, or believe the Product is defective and wish service under this
Limited Warranty, please contact your dealer or call us at:

TOLL FREE 1-888-281 5698 or contact us through our web site: www.dcsappliances.com.

You may be required to provide reasonable proof of the date of purchase of the Product before the Product
will be serviced under this Limited Warranty.

COMMERCIAL USE

This warranty applies to appliances used in residential applications; it does not cover their use in commercial
situations.

NO OTHER WARRANTIES

This Limited Warranty is the complete and exclusive agreement between you and Fisher & Paykel Appliances,
Inc. regarding any defect in the Product. None of our employees (or our Authorized Service Agents) are
authorized to make any addition or modification to this Limited Warranty.

Warrantor: Fisher & Paykel Appliances, Inc.
If you need further help concerning this Limited Warranty, please call us at the above number, or write to:

Fisher & Paykel Appliances, Inc.
Attention: DCS Customer Care
5900 Skylab Road, Huntington Beach, CA 92647

This Limited Warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.

Fisher & Paykel Appliances Inc. is a leading manufacturer of premium quality cooking and specialty
appliances under the Fisher & Paykel and DCS brands.

P/N 238915 RB 02/08

Fisher & Paykel Appliances, Inc.
5900 Skylab Road, Huntington Beach, CA 92647
Customer Care: 888.281.5698 • Fax: [phone]
www.dcsappliances.com