Dynamic Cooking Systems CMOTTK30 Installation Manual

MODEL CMOTTK30 CONVECTION MICROWAVE TRIM KIT

INSTALLATION INSTRUCTIONS

Before you begin, read these instructions completely and carefully.

Getting Started

■ Remove packaging

Contents Tools Required

Part Description Qty

Trim Assembly 1
Base 1
Rear Duct 1
Forward Duct 1
Foam Tape 2 ft
Mounting Bracket (L/R) 2
Sheet Metal Screws 14

1/8”Drill
#2 Phillip Screwdriver

Before installing trim kit, install the convection duct as follows:

1. Inser

2. Install foam tape on 2 flanges of the rear section of the duct (Fig. 02).

3. Remove and retain the 2 top screws, left and right, located at the rear vertical edges of the M icrowave

4. Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3 (Fig. 04).

t the rear section of the duct into the forward section of the duct and install 4 screws supplied

(Fig. 01).

(Fig. 03).

4 Screws

F

ig. 01

Fig. 03

Foam Tape

. 02

ig

F

Fig. 04

Foam
Tape

Installing T rim Kit

1/16"

1. Cut opening in the cabinet face per the following dimensions:
Height: 19-3/16”+ 1/16”, –0

Width: 25-3/4”+ 1/16”, –0

Note: Refer to diagram on the following page. The minimum

cabinet depth is 20”. When installing the Microwave
and Trim Kit in combination with a Wall Oven or
Warming Drawer, please follow the recommendations
in the Microwave Installation/ Use & Care Manual.

2. Add adequate platform base support in the bottom of the

cabinet for trim kit base to rest on.

3. Mark a centerline on the front edge of the cabinet bottom

(Fig. 05).

4. Place trim kit base and align centerline mark to the triangular

notch on the front edge of the base (Fig. 06).
Drill 1/8”pilot holes in the cabinet using the base as a template

5.

and install a scr
the base from shifting (Fig. 07).

6. Insert Microwave into opening on top of the base. The

Microwave feet should sit in the recesses on the base for correct
alignment. The Microwave should be plugged in at this point.

ew through the base into the cabinet to prevent

Fig. 05

Fig.06

Place the right and left mounting bracket supports by resting

7.

the bottom edges of the supports on the bottom of the cutout
(Fig. 08). The long flange on the side supports should clear the
side of the cutout b

y approximately 1/16”(see Fig. 09). Install
top screws into the cabinet face by first drilling 1/8”pilot holes
(see inserts 3 and 4).

8.

Install tr
cor

im kit fac

responding sockets on the t

e by inserting t

op pins of trim into

op corners of clip support plates

(see insert 1).

9. Finish the assembly by inserting the bottom pins into the
corresponding sockets on front edge of the base (see insert 3).
Check for proper door opening clearances.

ig. 07

F

Fig. 09

Bracket
Suppor
on the
bottom
of cutout

t

Fig. 08