BACKGUARD SYSTEM FOR PRO COOKTOPS
Installation Guide
MODELS:
BGC-3036
BGC-1236
BGC-3048
BGC-1248
A MESSAGE TO OUR CUSTOMERS
Thank you for selecting this Backguard System. Because of the unique features of this accessory we have
developed this Installation Guide. It contains valuable information on how to install your new Backguard System.
Keep this guide handy, as it will help answer questions that may arise as you use your new accessory.
For your convenience, product questions can be answered by a DCS Customer Care Representative by phone:
1-888-
936-7872
NOTE: Inspect the product to verify that there is no shipping damage. If any damage is detected, call the shipper
and initiate a damage claim. DCS by Fisher & Paykel is not responsible for shipping damage.
DO NOT discard any packing material (box, pallet, straps) until the unit has been inspected.
WARNING!
Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death.
Read the installation, operating and maintenance instructions thoroughly before installing, using or servicing this
equipment.
, or email:
customer.care@fisherpaykel.com
.
WARNING!
If the information in this manual is not followed exactly, a fire or explosion may result causing property damage,
personal injury or death.
Do not store or use gasoline or other flammable v
apors and liquids in the vicinity of this or any other appliance.
DANGER
If You Smell Gas:
1. Do not try to light any appliance.
2. Do not touch any electrical switch; do not use any phone in your building.
3. Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
4. If you cannot reach your gas supplier, call the fire department.
nstallation and service must be performed by a qualified installer, service agency or the gas supplier.
I
5.
WARNING!
To reduce the risk of injury to persons in the event of a cooktop grease fire, observe the following: Turn burner off
first. Smother flames with a close-fitting lid, cookie sheet, metal tray, baking soda or use a dry chemical or foamtype fire extinguisher. Be careful to prevent burns. If the flames do not go out immediately evacuate and call the
fire department. Never pick up a flaming pan - You may be burned. DO NOT USE WATER ON GREASE FIRES,
including wet dishcloths or towels - a violent steam explosion will result. Use an extinguisher ONLY if:
1. You know you have a Class ABC extinguisher, and you already know how to operate it.
2. The fire is small and contained in the area where it started.
3. The fire department is being called.
4. You can fight the fire with your back to an exit.
WARNING!
Do not place items of interest to children on racks or appliance. Children could be seriously injured if they should
climb onto or into the appliance to reach these items.
WARNING!
Do not place combustible material (paper, cloth, plastic, etc.) on the rack.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
1
TABLE OF CONTENTS
SPECIFICATIONS 3
ALL MOUNT LOW BACKGUARD INSTALLATION 3
W
WALL MOUNT FULL BACKGUARD INSTALLATION 4-5
2
SPECIFICATIONS
B
A
8-3/4 "
1
2 "
B
A
1-5/16 "
1-5/16 "
MODEL
AB
BGC-1236
BGC-3036
BGC-1248
BGC-3048
-
-
2
-
-
-
2
1
RACK
(16-5/8")
QTY.
R
ACK
(13-5/8")
QTY.
35-7/8"
35-7/8"
47-7/8"
47-7/8"
12"
30"
12"
30"
WALL MOUNT LOW BACKGUARD INSTALLATION
1. Locate and level cooktop per installation instructions.
2. After unpacking all backguard system parts, locate the Back Section 1/8” above and centered over the Trim
attached to the cooktop.* Secure Back Section to wall with the appropriate fasteners (not supplied)(fig. 01).
*After 1/8” is located, slots in back section may be used to adjust spacing between cooktop trim and
backguard for a flush fit.
3. Secure Front Section of backguard to Back Section with #8 self-tapping sheet metal screws supplied
(fig. 02).
Slots to choose desired spacing
between Cooktop Trim and
.
Backguar
16” for 30”
36” for 36/48”
d
tion
ec
Back S
Front Section
Back S
tion
ec
# 8
Self-tapping
sheet metal
ews
scr
Fig.01 Fig.02
Tri m
3