Dynalink DY56ASP Quick Setup Manual

56K Internal Modem

Quick Setup Guide

DY56ASP

56K Internal Modem Quick Set-up Guide

Introduction

This Quick Setup Guide summarises the
modem installation in four simple steps.
Please follo w each step exactly as described.
Upon completion of Step 4 you can be certain
that your modem is correctly installed.

To install a driv er, return to the previous menu
and click the MODEM DRIVERS button if you
are reading this Quick Set-Up Guide from the
supplied Dynalink CD. Otherwise, load the
supplied Dynalink CD, go to product page and
click the MODEM DRIVERS button.

To view or print the User’s Manual for this
modem, return to the previous menu and click
the VIEW USER MANUAL button.

Other CDs may be supplied by Internet Ser vice
Providers (ISPs) to enable you to establish an
Internet connection. Some fees may be payable
– please check the ISP’s CD for more information.
Once on the Internet you can visit Dynalink
Modems’ web site at www.dynalink.com.au
(Australia) or www.dynalink.co.nz (New Zealand)
to access fur ther helpful information.

Connect the modem to your pc

WARNING: Dynalink modems cannot be held responsible for any damage
sustained to the modem or pc during hardware installation. If you are not confident
in your ability to install this PCI Modem, please contact your computer dealer.

1. Turn your PC OFF.

2. Remove the cover of your PC, leaving the power cable plugged in but switched
o at the wall.

3. Earth yourself by touching the PC's metal casing.

4. Select an empty PCI slot (usually white) and remove the metal slot cover
using a small screwdriver.

5. Firmly insert the modem into the spare PCI slot.

6. Fasten the modem to the PC faceplate.

7. Replace the PC's co ver to complete the modem installation.

8. Plug the enclosed phone cable into the LINE jack of the modem and the wall
phone jack.

Install the modem drivers

1. Power ON your PC

2. To install a driver, return to the previous menu and click the MODEM DRIVERS
button if you are reading this Quick Set-Up Guide from the supplied Dynalink CD.
Otherwise, load the supplied Dynalink CD, go to product page and click the
MODEM DRIVERS button. Double click SE TUP.EXE to begin driver installation

3. Windows® will report that it has detected a new device.

Windows XP:

When the Hardware Update Wizard appears, select Install from a list or specific
location - Next. Select Search for the best driver, and then choose only the

option Include this location in the search. Browse to locate the path of the
driver: D:\Driver\WinXP (substitute D: with your CD drive letter), then OK – Next.
If a compatibility message appears, click Continue Anyway. Click Finish to
complete updating driver.

Note: Generic modem drivers that are installed by Windows XP automatically
can also be used with this modem.

1

2