Dynalink 56K, 1456VQH-T4 Quick Setup Manual

56K Internal Modem

Quick Setup Guide

1456VQH-T4

56K Internal Modem Quick Set-up Guide

1

Introduction

This Quick Setup Guide summarises the modem installation in four simple steps.
Please follow each step exactly as described. Upon completion of Step 4 you can
be certain that your modem is correctly installed.

To install a driver, return to the previous menu and click the MODEM DRIVERS
button if you are reading this Quick Set-Up Guide from the supplied Dynalink CD.
Otherwise, load the supplied Dynalink CD, go to product page and click the MODEM
DRIVERS button.

To view or print the User’s Manual for this modem, return to the previous menu and
click the VIEW USER MANUAL button.

Other CDs may be supplied by Internet Service Providers (ISPs) to enable you to
establish an Internet connection. Some fees may be payable – please check the ISP’s
CD for more information. Once on the Internet you can visit Dynalink Modems’ web
site at www.dynalink.com.au (Australia) or www.dynalink.co.nz (New Zealand) to
access further helpful information.

Connect the modem to your pc

WARNING: DYNALINK MODEMS CANNOT BE HELD RESPONSIBLE FOR ANY DAMAGE

SUSTAINED TO THE MODEM OR PC DURING HARDWARE INSTALLATION. IF YOU ARE
NOT CONFIDENT IN YOUR ABILITY TO INSTALL THIS PCI MODEM, PLEASE CONTACT
YOUR COMPUTER DEALER.

1. Turn your PC OFF.

2. Remove the cover of your PC, leaving the power cable plugged in but switched

off at the wall.

3. Earth yourself by touching the PC's metal casing.

4. Select an empty PCI slot (usually white) and remove the metal slot cover using

a small screwdriver.

5. Firmly insert the modem into the spare PCI slot.

6. Fasten the modem to the PC faceplate.

7. Replace the PC's cover to complete the modem installation.

8. Plug the enclosed phone cable into the LINE jack of the modem and the wall

phone jack.