Dynabrade Dynangle 14200 Disassembly And Assembly Instructions

Disassembly Instructions - 0.7 hp. Dynangle Air Motor

Models: 14200

Important: Use these instructions along with the tool parts page or manual.
Notice: Shut off the air supply and depress throttle lever to deplete the remaining air.

• Carefully disconnect the tool from the air supply hose. • Remove the cover and the abrasive
belt. • Use the Special Repair Tools designed for the disassembly and assembly of this motor.

Motor Disassembly:

1/8" Hex Key

1. Use a 1/8" hex key to loosen the 95530 Screw.

Remove the motor from the belt housing.

1/8" hex key

19 mm Wrench

2. Use a 19 mm wrench to hold the motor spindle. By hand, or with groove pliers, grasp the

drive wheel and remove it. Turn counterclockwise.

1-1/2" crowfoot wrench

3. Carefully fasten the 01739 Housing in a vise with aluminum or bronze jaws so that the

spindle is pointing up.

Use a 1-1/2" crowfoot wrench to remove the 01748 Exhaust Cover.
Turn counterclockwise.
Remove the 01744 Silencer.

Pull the motor out of the housing.

96346 Bearing Separator

4. Fasten the 96346 Bearing Separator (2") around the 01028 Cylinder. Place the separator

and the motor in the 96232 Arbor Press (#2) so that the rotor spindle is pointing down.

Use a 5/32" or 4 mm diameter flat end drive punch to push the rotor out of the 02649
Bearing.

96213 Bearing Removal Tool

96346 Bearing Separator

5. Use the 96213 Bearing Removal Tool and the arbor press to remove the 02649 Bearing

from the rear bearing plate.