Dwyer Instruments SERIES 1500 Catalog Page

Series

500

1

Temperature Controller

1/16 DIN, Microprocessor Based, Self-Tune

®

PID

.925 [125]

4

4.475 [114]

The Love Series 1500 Temperature Controller is a reliable, accurate and
fully programmable temperature control or alarm in an economical 1/16 DIN
case. Microprocessor based, all control functions are easily programmed from
the waterproof, corrosion resistant front panel. Models are available that accept
field selectable J, K or T type thermocouples or RTD 100Ω DIN (.00385
ohms/ohm/°C) inputs and provide SSR, Relay or 5 VDC Logic outputs. All mod­els are programmable for on-off, P, PI, manual PID or automatic Self-Tune®PID
control. Like the control output, optional alarm is field configurable direct act­ing (cooling) or reverse acting (heating) and is easily adjusted for either auto­matic or manual reset to provide independent high or low system protection.
Four security levels are password protected.

Model
15011
15111
15013
15113
15023
15123

Input

Thermocouple
Thermocouple
Thermocouple
Thermocouple
RTD (DIN)
RTD (DIN)

Output

SSR
SSR
Relay
Relay
Relay
Relay

Alarm

No
Yes
No
Yes
No
Yes

1.880
[48]

.450 [12]

ANEL CUTOUT FOR ALL MODELS 1.772˝ X 1.772˝ [45 mm X 45 mm]

P

ALLOW FOR 0.5˝ [13 mm] CLEARANCE AT THE REAR OF INSTRUMENT.

SPECIFICATIONS
Inputs: Thermocouple (J type stocked), field selectable K, T, E, or N

type; RTD (100Ω DIN).
Display: 4 digit, 7 segment 0.3˝ high LED display; Set Point and Alarm
status LED indicators; °F or °C LED indicators.

Accuracy: ±0.25% of span ±1 least significant digit.
Supply Voltage: 100 to 240 VAC, 50 – 400 Hz. single phase; 132 to

240 VDC (nom.) +10% – 20%. 5 VA maximum power consumption.
Temperature Range: Operating 14 to 131°F (-10 to 55°C); storage -40
to 176°F (-40 to 80°C).
Output Ratings: SSR: 3.5A @ 240 VAC max. @ 77°F (25°C) typical.
Relay (SPST): 3A res., 1.5A ind. @ 250 VAC; Pilot Duty = 250 VA, 2A @
125 VAC or 1A @ 250 VAC.

Alarm Rating (optional): Relay (SPST): 3A res., 1.5A ind. @ 250 VAC.
Isolation: Relay and SSR outputs are isolated.
Sensor Break Protection: De-energizes control output.
Weight: 8 oz (227 g).

* .125 [3]

1

.760

45]

[

R/C Snubber: Recommended for solenoid or contactor loads. Order
optional Part Number A-600.

No. A-600, R/C Snubber — For solenoid or contactor loads