dweLED CBWR1262 Installation & Assembly

INSTALLATION INSTRUCTIONS
366-Outdoor Pendant
PD-W36610
CAUTION: TO PREVENT ELECTRICAL SHOCK, ENSURE ELECTRICITY HAS BEEN TURNED OFF AT THE CIRCUIT BREAKER BEFORE BEGINNING
- Read all instructions before installing.
- System is intended for installation by a licensed electrician in accordance with the National Electrical Code (NEC) and local
regulations.
- When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.
- Retain installation instructions for future maintenance reference.
WARNING: All parts must be used as indicated in these instructions. This product is designed for use only with the supplied parts and/ or accessories designated for use by dweLED. Substitution of parts or accessories not designated for use with this product by dweLED could result in personal injury or property damage, and will void the warranty. Contact an authorized dealer or the manufacturer if any parts are damaged or missing.
MAINTENANCE NOTE: Coastal conditions may cause mineral and residue build-up on the fixture. We recommend that customers in coastal areas clean all external surfaces of the fixture once every two weeks with a wet cloth.
MISE EN GARDE: Pour éviter tout choc électrique, assurez-vous que le disjoncteur soit mis hors tension avant de commencer.
- Lisez toutes les instructions avant l’installation.
- Le système doit être installé par un électricien licensié conformément au code national de l’électricité (NEC), et également aux
règlements locaux.
- Lors de la manipulation du luminaire, n’appuyez pas sur les LED. Tenez-le uniquement par la base.
ATTENTION: Toutes les pièces doivent être utilisées comme indiqué dans ces instructions. Ce produit est conçu pour être utilisé seulement avec les pièces et/ou accessoires fournis pour être utilisés avec les produits dweLED. Remplacer des pièces ou accessoires non conçus pour ce produit dweLED pourrait causer des dommages corporels ou matériels et pourrait également causer l’annulation de la garantie. Veuillez contacter un revendeur autorisé ou le fabricant si des pièces manquent ou sont endommagées NOTE D’ENTRETIEN: Les conditions côtières peut causer une accumulation de minéraux et de résidue sur le luminaire. Nous recommendons aux clients qui resident dans les zones côtières de nettoyer toutes les surfaces externes du luminaire une fois toutes les deux semaines avec un chiffon humide.
HARDWARE
waclighting.com
Phone (800) 526.2588 Fax (800) 526.2585
A
Wire Connector Qty: 3pcs+1 Extra
Headquarters/Eastern Distribution Center
44 Harbor Park Drive Port Washington, NY 11050
B
Mounting Screw Qty: 1 Extra
1600 Distribution Ct Lithia Springs, GA 30122
C
Rubber Gasket
Qty: 1 Extra
Western Distribution Center
1750 Archibald Avenue Ontario, CA 91760
dweLED retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Jan 2019
1
INSTALLATION INSTRUCTIONS
366-Outdoor Pendant
PD-W36610
Fig.
1
A
B
3x12"Rods
PREPARATION
Junction Box
Wire Connector
Mounting Plate
Junction Box Screw
Fixture canopy
Mounting Screw
Swivel
Driver
Ground Wire
Rubber Gasket
C
1x6"Rod
Fixture
F
ig.2 Wiring
Fixture Wires
Black or Smooth
Fixture Wires
White or Ribbed
Fixture Wires
Bare wire (Ground)
House Wires
Black (Hot)
House Wires
White (Neutral)
House Wires
Green or Bare Copper (Ground)
Back Plate Dimensions
1w "
1a "
4w "
MOUNTING THE FIXTURE (Fig. 1)
4. Secure the mounting plate to the junction box using the screws provided with the junction box. NOTE: The side of the mounting plate marked “GND” must face out. body, rods and swivel. Make sure all are tightened.
CONNECTING THE WIRES (Fig. 2)
back plate using the green screw provided. After the
wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION
ig.3
F
Fig
.4
the mounting screw (B) and the rubber gasket (C).
8. For slope ceiling applications, rotate swivel at the
top of the stem to ensure luminaire is aiming down (Fig.3).
m
a
x25
9. To prevent moisture from entering the outlet box and causing a short, use clear caulking
(i.e. indoor/outdoor silicone sealant) to
ssary for installation.
cure. If your outlet box
wire directly to the
Junction Box
Caulking
waclighting.com
Phone (800) 526.2588 Fax (800) 526.2585
dweLED retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Jan 2019
Headquarters/Eastern Distribution Center
44 Harbor Park Drive Port Washington, NY 11050
1600 Distribution Ct Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue Ontario, CA 91760
2
Loading...