DW Drums DW 5000 Owner`s Manual

Two-Way Beater

Accelerator/Turbo

Chain & Sprocket or

Cam w/Nylon Strap

Hex Shaft

Base Casting

Footboard

Hinge

Heel Plate

Pedal Plate

Beater Shaft

Beater Hub

Stroke Adjustment

Rocker

Spring

Hoop Clamp

Height Adjustment

Spring Tension

Adjustment

Knurled Nut

Hex Nut

Spur

Hoop Clamp

Attachment

DrumKey Clip

O W N E R ’ S M A N U A L

The Infinite (Slotted) Stroke Adjustment can be used to var y the distance the beater travels before hitting the drum. For a

slightly heavier (longer) stroke move the screw towards the back, for a lighter (shor ter) stroke move the screw forwards.

The length of the beater rod can be adjusted to achieve the desired feel and impact area. Generally, the beater should hit

the center or an area 1-2 inches above the center of the dr um. Once the desired height is achieved, secure the beater hub

The 101 Two-Way Beater (standard) has both a cur ved, medium felt side for a rounder, warmer attack and a flat, hard

The adjustable beater weight can be positioned on the beater shaft to increase the power of the stroke.

To set the beater memor y lock, place it loosely on the beater shaft and place the beater shaft in the beater hub. Slide the

wrench (provided). The beater ball should automatically be positioned at a right angle to the memor y lock so that the beater

can be reversed from the soft felt to the hard plastic side by merely raising the beater and rotating it 180 degrees.

decrease the spring tension loosen the round knurled nut at the base of the spring assembly and pull down on the spring

to release the locking hex nut. Tighten or loosen the lock nut to the create the desired tension, then release the hex nut

The DW Toe Clamp is designed to fit a wide variety of manufacturer’s bass drum hoops. To set the space of the hoop

clamp for your bass drum, use the allen wrench (provided) to loosen the set screw on the clamp and then rotate the

the side wing screw securely. Use the provided rubber hoop protector to avoid damage to the bass drum hoop.

The length of the chain determines the angle of the footboard and, when adjusted in combination with the beater height

sprocket. The factor y settings are recommended for most general playing situations and preferred by many drummers.

To change the length of the nylon strap and footboard angle, remove the nut and washers from the screw on the cam, repo-

sition the chain or strap using one of the alternate links/holes. Then replace the nut and washers.

All DW Bass Dr um Pedals include built-in adjustable spurs and non-skid Velcro™ on the bottom of the pedal plates to