Duro-Last Auger Fasteners User Manual

DURO-LAST® AUGER FASTENER
Description:
The Duro-Last nylon with an internal square drive. A spe cially designed plate and fastener combination is manufactured with one
way tabs on the underside of the f astener head that lock into the ratchet teeth of the 2 inch (52 mm) metal plate.
The 2 inch (52 mm) metal plate is manufactured with barbs that maximize membrane holding power.
The auger fasteners are d esigned to attach insulation and roofing membrane to cementitious wood fiber, gypsum, and lightweight concrete decks. The auger fasteners surpass the FM 4470 specifications
Installation:
1. A 7/16 inch (12 mm) - 9/16 (14 mm) pilot hole is
required on gypsum and lightweight concrete decks depending on density of the deck. No pilot hole is required on cementitious wood fiber decks unless overlaying an exis ting r oof system in which case a hole must be drilled thru the roof system to the top of the roof deck.
2. Penetration into the deck is 1.5 inch (38 mm), minimum.
3. Install the fastener with a 1/4 inch (6.3 mm) square-drive bit. One bit is supplied in each box of
Auger fasteners.
Note:
On Factory Mutual insured projects, penetration is
2 inch (51 mm), minimum.
Duro-Last, Inc. stocks auger fasteners in the sizes
noted in the table to the right. Additional sizes, up to 14 inch (356 mm), are available on a drop ship basis. Please allow adequate time for orderi ng and delivery
of special orders.
® Auger F astener is made f rom glass-filled
DATA SHEET
Length
2 inch (5 1 mm)
2.5 inch (64 mm) 3 inch (76 mm)
3.5 inch (89 mm)
4 inch (102 mm)
4.5 inch (114 m m) 5 inch (127 mm)
5.5 inch (140 m m) 6 inch (152 mm)
6.5 inch (165 m m) 7 inch (178 mm)
7.5 inch (190 m m) 8 inch (203 mm)
8.5 inch (216 m m) 9 inch (229 mm)
10 inch (254 mm)
Quantity per
Box 500
500 500 500 500 500 500 500 500 500 500 500 500 250 250 250
Duro-Last: The Proven Performer®
www.duro-last.com
"Duro-Last " an d " The World's Best Roof" are registered marks owned by Duro-Las t , Inc.
23
800-248-0280
2009
Loading...