Duro-Last 4 Flex Fascia Cover User Manual

DATA SHEET

Material

Gauge

Finish

Aluminum

.040

Mill or Kynar®

Stainless Steel

24-gauge

N/A

Bonderized Steel

24-gauge

N/A

Galvalume

24-gauge

Mill or Kynar®

Copper

16 oz.

Mill

Description:

The 4” Flex Fascia Cover easily snaps onto the Duro­Last® vinyl 4” fascia bar. Pre-notched grooves every 3”
allow fascia cover to easily snap over radial surfaces.

Fabricated in 10’ lengths; 4” width.
Can be installed on both inside and outside

radius edges.

Manufactured from various metals (see chart

below).

Contact Duro-Last or EXCEPTIONAL® Metals to
request a color chart, samples and information
regarding custom metals and finishes.

Energy Efficiency:

4” Flex Fascia Cover

LEED® and ENERGY STAR® compliant; Recyclable.

Installation:

1. Attach to a wood nailer.

2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.

3. Install in accordance with Duro-Last detail
drawings #3510 and #3511.

4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.

Warranty:

Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.

Technical Services:

Product samples, detail sheets, color chips, and a color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.

“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012