Duro-Last 3 inch Metal Plate User Manual
DURO-LAST® 3-INCH METAL PLATE
Description:
The Duro-Last® Metal Plate is 0.024-inch
(0.6 mm) thick, 3 x 3 inch (76 x 76 mm)
square galvalume plate. Galvalume has
proven weatherability and resiliency. The
Duro-Last Metal Plates are packaged and
sold in quantities of 500.
Duro-Last Metal Plates are stamped to
include a recessed ¼ inch (6.4 mm)
diameter hole in the center and a series of
ribs for added strength. The configuration
of the ribs and the hole is used to prevent
the screw head from coming in contact with
the Duro-Last roofing membrane. The
Duro-Last Metal Plate is a long-lasting and
durable plate that is available only from
Duro-Last, Inc.
DATA SHEET
Installation:
1. Duro-Last Metal Plates may be used for
installation of insulation; fastening
around all penetrations; fastening
between the tabs on sheet edges which
are perpendicular to the tabs; and on
the parapet sections.
2. Duro-Last Metal Plates are also used
for installation of the Duro-Roof®
system. (See installation instructions
for the Duro-Roof® system).
3. When used in the Duro-Roof system
install the the plate so that it's edge is ¼
inch (6 mm) from the tab edge.
Duro-Last: The Proven Performer®
www.duro-last.com
"Duro-Last " an d " The World's Best Roof" are registered marks owned by Duro-Las t , Inc.
27
800-248-0280
2009
Loading...