Duro-Last 2-Piece Snap-On Compression LG System User Manual

DATA SHEET

Material

Gauge

Finish

Aluminum

.040

Mill or Kynar®

2-Piece Snap-On Compression LG

Description:

The 2-Piece Snap-On Compression LG (Large Face)
system may be used as a perimeter flashing for the
Duro-Last® roofing system. The system consists of a
22-gauge Galvalume® base and a snap-on aluminum
cover.

Base and cover is fabricated in 10’ lengths and

9” – 13” widths.

Cover is double-hemmed to prevent roof

material from excessive wear.
Bird beak strengthening bend on base.
Pre-punched holes in base.
Ready to assemble inside and outside corners

are available.

Contact Duro-Last or EXCEPTIONAL® Metals to
request a color chart, samples and information
regarding custom metals and finishes.

Energy Efficiency:

LEED® and ENERGY STAR® compliant; Recyclable.

Installation:

1. A wood nailer is required if 1” or greater of
insulation is used.

2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.

3. Install in accordance with Duro-Last detail
drawing #3115.

4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.

Codes and Standards:

chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.

Warranty:

Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.

Technical Services:

Product samples, detail sheets, color chips, and color

“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012

ANSI/SPRI ES-1 compliant.