Duro-Last 2-Piece Flex Snap-On Compression System User Manual

DATA SHEET

Material

Gauge

Finish

Aluminum

.040

Mill or Kynar®

Stainless Steel

24-gauge

N/A

Bonderized Steel

24-gauge

N/A

Galvalume

24-gauge

Mill or Kynar®

Copper

16 oz.

Mill

2-Piece Flex Snap-On Compression

Description:

The 2-Piece Flex Snap-On Compression system is
made with a flat face to help it conform to a radius edge.
The system consists of a 24-gauge Galvalume® base
and a snap-on cover notched in 3” intervals to easily
snap over radial surfaces.

This edge is fabricated in 10’ lengths; 3” – 8”

widths.

Cover is double-hemmed to prevent roof

material from chaffing.

Can be installed on both inside and outside

radius edges.

Standard 2-Piece Snap-On Compression can be

ordered with a flat face to match this detail.

This edge trim does not conform to an arched or

vaulted radius.

Contact Duro-Last® or EXCEPTIONAL® Metals to
request a color chart, samples and information
regarding custom metals and finishes.

Energy Efficiency:

LEED® and ENERGY STAR® compliant; Recyclable.

Installation:

1. A wood nailer is required if 1” or greater of
insulation is used.

2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.

3. Install in accordance with Duro-Last detail
drawings #3110 and #3513.

4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.

Warranty:

Duro-Last® offers a wide range of warranty coverage
for EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.

Technical Services:

Product samples, detail sheets, color chips, and a color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.

“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012