Page 1
IB-1125-WM-E-010304
PLEASE READ CAREFULLY BEFORE USE
MODEL 1125
Operating Instructions
PERSONAL AM/FM
STEREO CASSETTE PLAYER
WITH 3 BAND GRAPHIC EQUALIZER
PLAYS ALL STEREO CASSETTE TAPES
RECEIVES AM/FM BROADCASTS
3 BAND GRAPHIC EQUALIZER
STEREO HEADPHONES INCLUDED
BUILT-IN BELT CLIP
REQUIRES 2 SIZE AA BATTERIES
( NOT INCLUDED)
Page 2
IB-1125-WM-E-010304
LOCATION OF CONTROLS
21
3
4
8
5
6
7
1. FUNCTION SWITCH
2. TUNING CONTROL
3. STEREO HEADPHONE JACK
4. VOLUME CONTROL
5. FAST FORWARD BUTTON (FAST F.)
6. PLAY BUTTON
7. STOP BUTTON
8. 3 BAND GRAPHIC EQUALIZER - Adjusts for the tones
you prefer.
9. BELT CLIP (at the back of the set)
10. BATTERY DOOR (at the back of the set)
9
10
AUTOMATIC STOP - This set will automatically shut
itself off when the tape has finished playing, and the
PLAY button will pop up.
1
Page 3
IB-1125-WM-E-010304
Alkaline batteries are recommended and
will normally provide more playing time.
Do not mix old and new batteries.
Do not mix alkaline, standard
(carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
Congratulations! You now own a personal radio cassette player,
able to offer personal listening with your headphones, and
custom sound with your 3 band graphic equalizer.
LISTENING TO THE RADIO
You may listen to the radio through the stereo headphones.
1. Plug the headphone plug into the HEADPHONE jack.
2. Slide the FUNCTION switch to AM or FM position.
3. Select the desired station with the TUNING control (adjust for
clearest sound).
4. Adjust the VOLUME control for the most pleasing sound.
5. Adjust the 3 BAND EQUALIZER CONTROLS to your taste.
6. When listening is completed, slide the FUNCTION switch to
the TAPE position.
As the headphone cord functions as the FM antenna, do
not bunch it up. Unwind and extend the cord as much as
possible.
NOTE:
Remove both batteries during long periods (about 30 days
or more) of non-use, possible battery leakage and corrosion
can damage the set.
If the sound becomes weak and unclear, the batteries may
be weak. Replace both batteries at once.
BATTERY INSTALLATION
Slide the BATTERY DOOR as the arrow direction to open it,
and insert 2 size AA batteries, taking care not to reverse the
positive and negative polarities.
2
Page 4
IB-1125-WM-E-010304
TO INSERT THE TAPE
1. Open the cassette door by holding the door as shown
and gently pulling it to you.
2. Insert a recorded tape into the cassette holder ON THE
DOOR.
3. Close the cassette door gently till it clicks shut.
CAUTION: Do not pull door too strongly, or you may
damage the door. Treat this set with care
and it will last a long time.
TAPE PLAY
1. Check whether or not the tape is tight before it is
inserted.
2. Open the cassette door by hand, face the side to be played
toward you, and insert the cassette tape. Close the cassette
door.
3. Connect the headphones to the HEADPHONE jack
and adjust the headphone band for proper fit.
4. Press the PLAY button.
5. Adjust the VOLUME to control the sound level you
like.
6. To skip portions of the cassette tape, press the FAST
FORWARD button.
7. To stop playing, press the STOP button, and the power
source is also shut off.
(This set has a built-in auto-stop and the tape mechanism
will stop playing and shut off when it reaches the end of the
tape.)
8. To hear the other side of tape, flip it over and press PLAY.
To keep the tape from
tangling, firmly wind the
tape before inserting it into
the player.
Use of a cassette with
more than 90 minutes,
such as C-120 (120
minutes), is not
recommended. The
extreme thinness of this
tape may damage this set.
3
Page 5
IB-1125-WM-E-010304
TO HEAR THE SAME SONG AGAIN
1. Remove the tape, flip it around to the other side and insert
it.
2. Press the FAST FORWARD button for a short time.
3. Remove tape, flip it around to the original side,
re-insert and press the PLAY button.
CLEANING TAPE HEAD
If the sound drops out or excessive
noise occurs, clean the magnetic
head, capstan and pinch roller with
a cotton swab moistened with
alcohol.
TROUBLE SHOOTING
PROBLEM CHECK THE FOLLOWING
No sound
Is the headphone plugged into the jack?
- Plug it in now.
Is the VOLUME control at minimum?
- Raise the volume.
Are the batteries old or dead?
- Replace both batteries.
PLAY button will
not stay down
The tape has reached the end. Remove the
tape, flip it over to the other side and insert
into cassette door and press PLAY.
AM/FM
reception weak
Rotate the set for better AM or bring it
closer to a window. For FM, extend the
headphone wire straight.
Poor quality
playback after
playing a long
time
1. Check if both batteries are fresh and
inserted correctly.
2. Use a tape cleaning cassette tape to
clean the tapehead (available at most
radio stores).
Tape stops in
middle of play
Try a different tape. Tape may be damaged.
Also try fast forwarding tape till the end.
NORMAL BATTERY LIFE USING ALKALINE BATTERIES IS ABOUT 6
HOURS OF CASSETTE PLAYING TIME.
PINCH ROLLER
CAPSTAN
COTTON SWAB
MAGNETIC HEAD
Tape jamming or
tangling
1. Use only better quality tapes.
2. Do not use a cassette with more than 90
minutes.
3. Make sure there are no loose layers of
tape visible before inserting the cassette.
4
GRAPHIC EQUALIZER
This set has a 3 BAND GRAPHIC EQUALIZER which you
may adjust the tone of the music to your taste.
Page 6
IB-1125-WM-E-010304
© 2004 LENOXX ELECTRONICS CORP.
2 GERMAK DRIVE
CARTERET, N.J. 07008
MADE & PRINTED IN CHINA
For Customer Service Dial: 1-800-315-5885
(MONDAY-THURSDAY 09:00AM-05:00PM, FRIDAY 09:00AM-01:00PM EST.)
or Visit Our Website: http://www.lenoxx.com
GENERAL SPECIFICATION
Speed deviation
: +3% -2%
Frequency response
Output power (Max)
: More than 20 mw/ch
Power source
: 2 size AA alkaline batteries
Tape Section
:Standard normal bias cassette tape
70Hz - 10kHz
Radio Section
Frequency range:
AM: 530 - 1700 kHz
FM: 88 - 108 MHz
5
LIMITED WARRANTY
We warrant this product to be free from defects in material and
workmanship under normal use for a period of 90 days after purchase
and we will repair it free of charge or replace it at no charge, should it
become defective under this warranty, providing you submit proof of
purchase (sales slip) with the set.
During the initial 90 day period after original purchase, we will
service or exchange, at no charge, the set that is returned to LENOXX
ELECTRONICS CORP. After the initial 90 day period expires, and for
a period of 12 months from original purchase, we will repair the unit
covering any part(s) that need to be replaced at no charge, but will
charge for the cost of labor, return postage paid by LENOXX.
This warranty does not apply to any products which have been
subject to misuse, neglect or accident. This warranty does not cover
broken headphones or cabinet. UNDER NO CIRCUMSTANCES WILL
LENOXX ELECTRONICS CORP. BE LIABLE FOR ANY INCIDENTAL
OR CONSEQUENTIAL DAMAGES. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. The following charges
apply to repairs beyond the warranty period: $4.00. Be sure to pack
carefully and return postage paid insured together with your money
order (personal checks will not be accepted) and sales receipt to:
LENOXX ELECTRONICS CORP., 2 GERMAK DRIVE, CARTERET N.J.
07008
Loading...