DUPLO A1 User Manual

User Manual

Since this module is not sold to general end users directly, there is no user manual of
module.

For the details about this module, please refer to the specification sheet of module.

This module should be installed in the host device according to the interface specification
(installation procedure).

(1) The following information must be indicated on the end product;
Contains FCC ID: 2AJ6GA1
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
*If it is difficult to describe this statement on the host product due to the size,
please describe in the User's manual.

(2) The following statements must be described in the user manual of the end
product;
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.