Dunlop Manufacturing DB01 User Manual
OWNER’S MANUAL
CONGRATULATIONS ON CHOOSING THE DIME CRYBABY®WAH PEDAL.
LIKE ALL DUNLOP PRODUCTS, THIS UNIQUE EFFECT IS DESIGNED TO
GIVE YOU QUALITY SOUND THROUGH YEARS OF DEPENDABLE SERVICE.
THE DIME CRYBABY
®
WAH PEDAL HAS OUR CELEBRATED RANGE
SWITCH, VARIABLE Q, AND VOLUME CONTROL. THESE CONTROLS
ALLOW YOU CHANGE THE SWEEP RANGE TO SIX DIFFERENT SETTINGS,
TO ADJUST THE VOCAL-LIKE CHARACTERISTICS OF THE FILTER, AND
VARY YOUR OUTPUT LEVEL WITH A SWITCH ACTIVATED BOOST CONTROL WITHIN A 0 TO 15 DB RANGE. THESE FEATURES, AND A SPECIAL
TAPERED POTENTIOMETER, MAKE THE DIME CRYBABY
®
LIVE UP TO
THE NAME “CRYBABY
®
.”
THE NEW FEATURE ON THIS PEDAL IS THE FINE TUNE ADJUSTMENT,
THAT ALLOWS YOU TO ADJUST YOUR RANGE SWEEP TO YOUR DESIRED
EXPRESSION RANGE.
SETUP INSTRUCTIONS
■
Insert a 9-volt battery (see box below) and/or plug in AC
ECB03 regulated adapter. The Dime Crybaby
®
Wah pedal will
operate on either power source.
■
Run a chord from your amplifier input into the Crybaby®’s
amplifier jack and guitar output to the input.
■
Turn on your amplifier and begin playing. By depressing the
toe of the pedal down and clicking the toe switch, the pedal
is turned on and off alternately.
■
To turn the pedal on, rock the pedal towards the toe down
position.
WHERE SHOULD YOU PUT YOUR WAH?
Most players put their wah-wah pedal before any time based
or ambient effect, such as reverb, delay/echo, chorus, flange,
or vibrato. This adds these effects to their selected wah-wah
sound.
BATTERY INSTALLATION
The Dime Crybaby
®
Wah pedal is shipped from the factory without a battery to
prevent possible damage from leakage.
A battery must be installed to operate the Dime Crybaby®unless an AC
adapter is used. When using a battery, the life of the battery can be greatly
extended if you unplug the input when the effect is not in use for long periods
of time. The Dime Crybaby
®
uses the Dunlop ECB03 Adapter (ECB03E for
Europe), a 9-volt DC regulated AC adapter. Plug is positive on barrel and negative in the center.
To install the battery, remove the battery cover from the bottom plate of the pedal,
connect the battery clip, place battery into cavity, and replace battery cover.
Loading...