Dunlop WAH SC95 User Manual

CRY BABY CLASSIC WAH

Jimdunlop.com

DUNLOP MANUFACTURING, INC. P.O. BOX 846 BENICIA, CA 94510 U.S.A. TEL: [phone] FAX: [phone]

92503012781revB

SC95 SLASH CRY BABY CLASSIC WAH OWNER’S MANUAL

SC95 SLASH CRY BABY® CLASSIC WAH

POWER

The Slash Cry Baby Classic Wah is powered by one 9-volt battery (accessed via bottom
of pedal), a 9-volt AC adapter such as the Dunlop ECB003/ECB003EU, or a DC Brick™
power supply.

SETUP INSTRUCTIONS

• Run a shielded instrument cable from your guitar to the SC95’s Instrument jack.

• Run another shielded instrument cable from the SC95’s Amplifier jack into your
amplifier input.

• Turn on the amplifier and begin playing.

• To turn the pedal on/off, push the toe of the pedal down until you feel a “click”.

• By rocking your foot back and forth on the pedal, you can change the effect that
the SC95 has on the tone of your instrument instantaneously.

• Blue LEDs on both side’s of the pedal indicate ON/OFF status.

SPECIFICATIONS

Inductor Custom wound low noise 560 millihenry high "Q" torroid
Input Impedance .7 MEG
Output Impedance <1 K
Sweep range 340 Hz - 1.7 KHz
Signal To Noise >102 dB A weighted
Bypass Hardwire DPDT bypass
Effect on LED's Located on both sides of pedal

Power Requirements +9 VDC @ <3 ma., 5.5mm x 2.1mm positive barrel & negative
center or standard 9-volt battery.

SLASH-APPROVED TREAD

ON/OFF STATUS LEDS

TOP-QUALITY INPUT
AND OUTPUT JACKS

HEAVY DUTY

BYPASS SWITCH