Dunlop MXR M269SE Carbon Copy Bright Data Sheet

M269SE CARBON COPY®

BRIGHT ANALOG DELAY

jimdunlop.com

92503018029REVA

M269SE CARBON COPY® BRIGHT ANALOG DELAY

DESCRIPTION

• 100% analog bucket-
brigade technology

• Up to 600ms of delay with
switchable modulation

• Internally adjustable
modulation circuit

• True bypass

CONTROLS

MOD switch toggles modulation
on/off (blue LED indicates on)

MIX knob controls blend of
wet and dry signals

REGEN knob sets number
of repeats

DELAY knob sets delay time

FOOTSWITCH toggles
effect on/bypass (blue LED
indicates on)

POWER

The Carbon Copy Bright Analog
Delay is powered by one 9-volt
battery (remove bottom plate to
install), a 9-volt AC Adapter such
as the Dunlop ECB003/ECB003EU,
or the DC Brick™ and Iso-Brick™
power supplies.

DIRECTIONS

• Run a cable from your guitar
to the M269SE’s INPUT jack and
another cable from the M269SE’s
OUTPUT jack to your amplier.

• Start with all controls at
12 o’clock.

• Turn the effect on by depressing
the footswitch.

• Rotate the REGEN knob clock­wise to increase the number of
repeats or counterclockwise to
decrease it.

• Rotate the MIX knob clockwise
to increase the ratio of wet to
dry signal or counterclockwise

results in 50/50 wet/dry mix while
fully counterclockwise results in
100% dry signal.

• Rotate the DELAY knob clockwise
to increase delay time or counter­clockwise to decrease it.

• Push in the MOD switch to add
modulation to your delay signal.
Modulation width and speed
can be adjusted internally
(remove bottom plate) with
a 3mm slotted screwdriver
(see Diagram A).

DIAGRAM A

to decrease it. Fully clockwise

SAMPLE SETTINGS

SUNNY SLAP CLEARLY ON

VIBRANT
AMBIANCE

THE EDGE

SPECIFICATIONS

Input Impedance 1 MΩ
Output Impedance 1 kΩ

Max Input Level +5 dBV,

500 Hz

Max Output Level +8 dBV

Noise Floor*

Mix at Max CW -96 dBV
Mix at Max CCW -104 dBV

Delay Distortion <1%, 1 kHz,

-5 dBV Input

Delay Time 20 ms to

600 ms
Noise Reduction 2:1 ratio
Modulation Speed 0.2 Hz to

2.2 Hz

Bypass True Hardwire
Current Draw 26 mA
Power Supply 9 volts DC

*Regen at max CCW, A-weighted

DUNLOP MANUFACTURING, INC.

P.O. BOX 846, BENICIA, CA 94510 U.S.A.

TEL: [phone] FAX: [phone]