Dunlop MXR M264 Fet Driver Data Sheet

92503014505revA

M264 FET DRIVER

M264 FET DRIVER

DESCRIPTION

• Organic, amp-like overdrive
and distortion

• Two-band EQ section for detailed

shaping of distorted signal

• True bypass switching

CONTROLS

HI knob cuts or boosts

high frequencies

LEVEL knob controls

overall effect volume

HI CUT switch rounds off

high frequencies when
playing at high volumes
(green LED indicates on)

DRIVE knob controls overall

amount of distortion

5 LO knob cuts or boosts

low frequencies

6 FOOTSWITCH toggles effect on/

bypass (red LED indicates on)

POWER

The MXR FET Driver is powered
by one 9-volt battery (remove
bottom plate to install), a 9-volt
AC adapter such as the Dunlop
ECB003/ECB003E, or a DC Brick
power supply.

DIRECTIONS

• Run a cable from your
guitar to the FET Driver’s
INPUT jack and run another

™

cable from the FET Driver’s

OUTPUT jack to your amplier.

• Start with all controls at

12 o’clock.

• Turn the effect on by depressing

the footswitch.

• Rotate the LEVEL knob clockwise

to increase overall volume of
effect or counterclockwise to
decrease it.

• When playing at loud volumes,

the HI CUT switch can be used
to roll off high frequencies for a
rounder, slightly warmer sound.

SAMPLE SETTINGS

OVER D CLIFF FLOYD THE PIGROYAL ALBERT

HALL

Note that this frequency cut
occurs at an earlier stage than
any cutting or boosting from the
HI and LO controls and therefore
does not affect the behavior of
either.

• Rotate the HI knob clockwise

to boost high frequencies or
counterclockwise to cut them.

• Rotate the LO knob clockwise

to boost low frequencies or
counterclockwise to cut them.

• Rotate the DRIVE knob
clockwise to increase amount
of distortion or counterclockwise
to decrease it.

SPECIFICATIONS

Input Impedance 1 MΩ
Output Impedance 15 kΩ

Noise Floor* -88 dBV

Bypass True Hardwire

Current Draw 25 mA
Power Supply 9 volts DC

*A-weighted

DUNLOP MANUFACTURING, INC.

P.O. BOX 846 BENICIA, CA 94510 U.S.A.

TEL: [phone] FAX: [phone]