Dunlop MXR M-169 Carbon Copy Data Sheet

92503006607revD

M169 CARBON COPY® ANALOG DELAY

M169 CARBON COPY® ANALOG DELAY

DESCRIPTION

• 100% analog bucket-
brigade technology

• Up to 600ms of delay with
switchable modulation

• Internally adjustable
modulation circuit

• True bypass

CONTROLS

MOD switch toggles modulation

on/off (blue LED indicates on)

MIX knob controls blend

of wet and dry signals

REGEN knob sets

number of repeats

DELAY knob sets delay time

FOOTSWITCH toggles

effect on/bypass (blue LED
indicates on)

POWER

The MXR Carbon Copy Analog
Delay is powered by one 9-volt
battery (remove bottom plate to
install), a 9-volt AC Adapter such
as the Dunlop ECB003/ECB003EU
or a DC Brick

™

power supply.

DIRECTIONS

• Run a cable from your guitar
to the Carbon Copy’s INPUT
jack and another cable from the
Carbon Copy’s OUTPUT jack to
your amplier.

• Start with all controls at 12
o’clock.

• Turn the effect on by depressing
the footswitch.

• Rotate the REGEN knob
clockwise to increase the number
of repeats or counterclockwise to
decrease it.

SAMPLE SETTINGS

MEMPHIS SLAP SKANK’N DUBGOLDEN AGE

GUITAR GOD

• Rotate the MIX knob clockwise
to increase the ratio of wet to
dry signal or counterclockwise
to decrease it. Fully clockwise
results in 100% wet signal while
fully counterclockwise results in
100% dry signal.

• Rotate the DELAY knob clockwise
to increase delay time or
counterclockwise to decrease it.

• Push in the MOD switch to add
modulation to your delay signal.
Modulation width and speed
can be adjusted internally with
a 2mm slotted screwdriver
(see Diagram A).

DIAGRAM A

SPECIFICATIONS

Input Impedance 1 MΩ
Output Impedance 1 kΩ

Max Input Level +5 dBV at 500 Hz
Max Output Level +8 dBV

Noise Floor*
Mix at Max CW -96 dBV
Mix at Max CCW -104 dBV

Delay Distortion <1% at 1 kHz,

-5 dBV Input
Delay Time 20 ms to 600 ms
Noise Reduction 2:1 ratio
Modulation Speed 0.2 Hz to 2.2 Hz

Bypass True Hardwire

Current Draw 26 mA
Power Supply 9 volts DC

*Regen at max CCW, A-weighted

DUNLOP MANUFACTURING, INC.

P.O. BOX 846 BENICIA, CA 94510 U.S.A.

TEL: [phone] FAX: [phone]