Dunlop KH-95 User Manual
KIRK HAMMET T
KH95 KIRK SIGNATURE CRYBABY WAH
Congratulations on your purchase of the KH95 Crybaby Wah
from D u n l o p. D u n lo p i s t he m o s t tr u s t ed n a m e in w a h p ed a l
ma nuf a ctu rin g a nd th e KH9 5 C ryb aby i s des i gne d to gi v e you
unparalleled sound quality and years of dependable service. Please
take a minute to read through this manual so you can get the most
out of your KH95 Crybaby Wah.
Developed in close collaboration with the metal guitar icon himself,
it has been meticulously tuned and tweaked to deliver the wah-wah
sound that revolutionized metal solos in the ‘80s and for all time to
come. This is the legendary tone that Kirk dials in on tour. Dunlop’s
engineers took Kirk’s EQ, volume a nd t on e settings—reflecting
decades of blazing Crybaby riffology—and reproduced them with
exacting precision. The Kirk Hammett Wah is exceptionally even in
response as you move from heel to toe, with a thick top end and full
dynamic range. Dare to step into the footprint of a giant.
DUNLOP MANUFACTURING, INC. P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL: 1-707-745-2722 FAX: 1-707-745-2658 WWW.JIMDUNLOP.COM
CUSTOM TRANSLUCENT
GREEN BURST FINISH
TOP-QUALITY INPUT
AND OUTPUT JACK
KIRK-APPROVED
SKELETON BONE TREAD
HEAVY DUTY
BYPASS SWITCH
92503008027
POWER
The Kirk Hammett Signature Wah can be powered by one 9-volt battery (accessed
via the bottom of the pedal), a Dunlop ECB003 AC adapter (ECB003E in Europe)
or a Dunlop DCB10 DC Brick power supply.
OWNER'S MANUAL
SETUP INSTRUCTIONS
A) Run a shielded instrument cable from your guitar to the KH95’s
Instrument jack.
C) Run another shielded instrument cable from the KH95’s Amplifier
jack into your amplifier input.
D) Turn on the amplifier and begin playing.
E) To turn the pedal on/off, push the toe of the pedal down until
you feel a “click”.
SPECIFICATIONS
Filter Parameter
• Low Pass ..........................................300 Hz ~ 380 Hz
• High Pass.......................................... 1.4 kHz ~ 1.8 kHz
• Kirk’s Proprietary Post Wah EQ Settings
Input Impedance (Wah Effect ON) ......680K Ω
Output Impedance (Wah Effect ON) ... 4.7K Ω
Bypass ...................................................True Hard Wired Bypass
Maximum Input Level...........................-13.5dBV (@ Filter’s Center Frequency)
Maximum Output Level ........................+6.5dBV
Maximum Gain (Toe Down)..................+21dB @ 1.4 kHz ~ 1.8 kHz
Maximum Gain (Heel Down) ............... +17dB @ 300 Hz ~ 380 Hz
Signal to Noise ....................................Heel Down >95dBV, Toe Down >89dBV, ‘A’ weighted
Power Draw ..........................................4mA @9V DC (36mW no load)
Note: 0dBV ref = 1Vrms
Loading...