Dunlop JH-1B User Manual

JH-1B JIMI HENDRIX

SIGNATURE WAH

The wah-wah pedal was just invented when Hendrix burst on
the scene in 1967. And to this day, few players’ names are more
synonymous with killer wah leads and wicked, wah-driven
syncopated rhythms. The wah pedal that Hendrix used was a
60s design by the Thomas Organ Company and manufactured
by JEN in Italy. This is the unmistakable wah tone heard on
Hendrix classics like “Up From the Sky,” “Voodoo Child (Slight
Return),” “Little Miss Lover” and “Still Raining, Still Dreaming.”

The Jimi Hendrix Signature Wah reproduces these timbres, and
more, with startling accuracy. Throaty and expressive, it will
fire your imagination. The vintage classic look is 100%
authentic too, with a flashy chrome top and sleek black Italian
crinkle finish aluminum body. From its eye-catching look to its
mind-bending sound, everything about this wah just screams
Hendrix.

DUNLOP MANUFACTURING, INC. P.O. BOX 846 BENICIA, CA 94510 U.S.A.

TEL: [phone] FAX: [phone] WWW.JIMDUNLOP.COM

92503005703

TECHNICAL SPECIFICATIONS

- Filter Parameters

- Low Pass .......................................290Hz - 310Hz

- High Pass .......................................1400Hz –1510Hz

- Input Impedance .....................................800K

- Output Impedance...................................10K

- Maximum Input Level ............................8.0dB

- Maximum Output Level ..........................+10dB

- Maximum Gain (Toe Down) ...................+16.5dB ............ @ 1400Hz ~ 1510Hz

- Maximum Gain (Heel Down) .................+16.5dB ............ @ 290Hz ~310Hz

- Power Requirements..............................900µA

VINTAGE STYLE
RUBBE R GASKET AND
STEEL BOTTOM P LATE

DESCRIPTION

• The original 60’s wah, with Jimi’s custom modifications!

• Lowers the effect’s frequency range for fatter, more open sound

• Vintage-style construction and premium electronics

DIRECTIONS

To set up the Jimi Hendrix JH-1B Wah, plug your instrument and amplifier cords
into the proper jacks. (The words “Instrument” and “Amplifier” are on the rubber
footpad.) Press the pedal all the way down to the toggle the Effect On footswitch.
Then you can control the wah effect with the pedal travel. To turn it off, press
the pedal all the way down again. If you rock the pedal all the way up and down,
you’ll get an intense wah effect. If you rock the pedal within a limited range
(within an inch or less), you’ll get a subtle effect.

POWER

Single 9-volt alkaline battery or Dunlop ECB03 AC Adapter

CONTROLS

• Pedal sweeps 100K ohm Hot Potz potentiometer for quick wah ramping

• Effect On/Bypass toggle switch at bottom of pedal travel

JEN-S TYLE ALUM INUM

HOUSI NG

ITALIAN

CRINK LE FINISH

ORIGI NAL ROCKE R

TREAD DESIG N

HEAVY-DUT Y

BYPASS SWITCH

TOP-Q UALITY

INPUT AND OUTP UT

JACKS