Page 1
JC95B
JERRY CANTRELL CRY BABY® WAH
Page 2
EXTERNAL CONTROLS
1
1 FINE TUNE knob adjusts tone of toe-down rocker position
JC95B JERRY CANTRELL CRY BABY® WAH 2
Page 3
BASIC OPERATION
POWER
The Jerry Cantrell Cry Baby® Wah is powered by one 9-volt battery
(remove bottom plate to install), the Dunlop ECB003 9-volt adapter,
or the DC Brick™, Iso-Brick™, and Mini Iso-Brick™ power supplies.
OPERATION
1. Run an instrument cable from your guitar to the JC95B’s
INSTRUMENT jack and another instrument cable from the JC95B’s
AMPLIFIER jack into your amplifier’s input.
2. Push the toe of the pedal down until you feel a “click” to turn the
pedal on/off.
3. Rotate the FINE TUNE knob clockwise for a brighter toe-down
response or counterclockwise for a darker toe-down response.
4. Rock your foot back and forth on the pedal to hear the vocal,
expressive tones that the Cry Baby Wah is famous for.
JC95B JERRY CANTRELL CRY BABY® WAH 3
Page 4
SPECIFICATIONS
IMPEDANCE
Input Impedance 1MΩ
Output Impedance 10MΩ
FILTER CENTER FREQUENCY
Heel Down 320 Hz to 390 Hz
Toe Down Fine Tune Max 1700 Hz to 2070 Hz
Toe Down Fine Tune Min 1050 kHz to 1270 Hz
MAXIMUM LEVEL
Input -11.5 dBV
Output +6 dBV
MAXIMUM GAIN AT CENTER FREQUENCY
Heel Down +18 dBV
Toe Down +20 dBV
NOISE FLOOR*
Heel Down >97 dB
Toe Down >89 dB
Bypass Hardwire
Current Draw 1 mA
Power Supply DC 9 volts
* VREF=1VRMS, A-weighted
JC95B JERRY CANTRELL CRY BABY® WAH 4
Loading...