Dunlop EVH Phase 90 User Manual

92503003509 revB

EVH90 PHASE 90

DESCRIPTION

• Deep, rich phasing

• SCRIPT switch toggles

between old school and
modern phase sounds

• Custom EVH paint job

CONTROLS

SCRIPT switch engages

Script mode

SPEED knob controls

overall eect rate

FOOTSWITCH toggles

eect on/bypass (blue
LED indicates on)

POWER

The EVH Phase 90 is powered by
one 9 volt battery (remove bottom
plate to install), a 9 volt AC adapter
such as the Dunlop ECB003/
ECB003EU, or a power supply
such as the DC Brick™.

DIRECTIONS

• Run a cable from your guitar to
the EVH Phase 90’s INPUT jack
and run another cable from the
EVH Phase 90’s OUTPUT jack
to your amplier.

• Start with the SPEED knob at

12 o’clock.

• Turn the eect on by depressing
the footswitch.

• Rotate the SPEED knob
clockwise for a faster phase
eect or counterclockwise
for a slower phase eect.

• Leave the SCRIPT switch out for
modern Block logo phase sounds
or push it in for vintage Script
logo phase sounds.

SPECIFICATIONS

Input Impedance 1 MΩ
Output Impedance 10 kΩ

Signal to Noise* >96 dB

Bypass Hardwire

Current Draw 8.2 mA
Power Supply 9 volts DC

*A-weighted, Vref = 1 Vrms

DUNLOP MANUFACTURING, INC.

P.O. BOX 846 BENICIA, CA 94510 U.S.A.

TEL: [phone] FAX: [phone]