Dunlop DVP3 User manual

92503014352REVD

OPERATION MANUAL

TM

DVP3 VOLUME (X) PEDAL

DESCRIPTION

• Control your volume levels or
effects pedals with exacting
precision

• Patented Low Friction Band-Drive
for highly reliable action

• Fully adjustable rocker tension

DIRECTIONS

• We recommend placing the Volume
(X) at the beginning of your effects
signal chain. Run a cable from your
guitar to the Dunlop Volume (X)’s
Input jack.

• Optional: Run a cable from the

Tuner output to a tuner. Signal

to tuner is active regardless of
rocker position.

VOLUME MODE (250 kΩ POT)

• Run a cable from the Volume (X)’s
Output jack to your amplifier.

• With the pedal in full toe-down
position, set your guitar and amp’s
maximum desired volume level.

• Move the rocker pedal toward the
heel-down position to decrease
the volume.

• The output signal will be muted
when the rocker pedal reaches
full heel-down position.

EXPRESSION MODE (10 kΩ POT)

• Run a stereo or TRS cable from the
Volume (X)’s FX jack to your effects
pedal's expression jack.

• With the pedal in full toe-down
position, set the effect parameter
you want to control to the desired
maximum level.

• Optional: To set the effect
parameter’s minimum level, use
internal potentiometer toward
the front of the pedal. Turn it
clockwise to raise the minimum
level or counterclockwise to lower
it. Note: factory setting is fully
counterclockwise.

• Move the rocker pedal toward the
heel-down position to lower the
value of the effect parameter within
the range set by your effect pedal’s
control and the Volume (X)’s internal
potentiometer.

• When the rocker is fully heel-down,
the effect parameter will be at
the minimum value as set by the
internal potentiometer.

• Optional: Use the internal blue push
switch to reverse the function of
heel-and toe-down postions.

CONTROLS

• OUTPUT jack for volume signal control

• FX output for effect parameter control

• TUNER jack for constant signal
to tuner

• INTERNAL 50 kΩ POT for setting
minimum heel-down value, wired in
series with expression pot

• INTERNAL SWITCH for reversing
foot/heel polarity

ADJUSTABLE TORQUE

To adjust rocker pedal torque, place

pedal in toe-down position. Insert a

1/4" flat blade screwdriver into torque

adjust screw located under heel-end
of rocker pedal. Turn clockwise to
increase resistance or counterclockwise
to decrease resistance.

POWER

The Dunlop Volume (X) is a passive

unit and does not require a power
source to operate.

DIMENSIONS OF PEDAL

Height 2.575" (65.4 mm)
Width 3.858" (98.0 mm)
Length 10.000"(253.8 mm)
Weight 2 lbs. 12 oz. (1.242 Kg)

DUNLOP MANUFACTURING, INC.

P.O. BOX 846 BEN ICIA , CA 94510 U.S .A.

TEL : [phone] FAX: [phone]