Dunlop Cry Baby Mini Wah CBM95 Data Sheet

THE ORIGINAL SINCE 1967.

®

92503017840REVA

®

CBM95 CRY BABY

POWER

The Mini Cry Baby® Wah is powered by
one 9-volt battery (accessed via the bottom
of the pedal), an AC adapter such as the
Dunlop ECB003/ECB003EU, or a DC

™

power supply.

Brick

SETUP INSTRUCTIONS

• Run a shielded instrument cable

from your guitar to the CBM95’s
INSTRUMENT jack.

• Run another shielded instrument cable
from the CBM95’s AMPLIFIER jack into
your amplifier input.

• Turn on the amplifier and begin playing.

• To turn the pedal on/off, push the toe of
the pedal down until you feel a “click.”

MINI WAH

• By rocking your foot back and forth on
the mini pedal, you can instantaneously
change the effect that the Cry Baby Wah
has on the tone of your instrument.

• Located under the rocker at the heel of
the pedal is an adjustable torque clutch
that allows the amount of resistance
the rocker has to being moved. Turn
clockwise to increase resistance or
counterclockwise to decrease resistance
(Wrench included).

• Internal VOICING switch allows you
to change the frequency range of the
CBM95. To access, remove bottom
plate. Default setting is H—High, for
the standard GCB95 sound. For a more
vintage, midrange-focused sound, set
the switch to M. For the lower frequency
range used in our Jimi Hendrix
select L.

See Diagram A

DIAGRAM A

™

Wah,

SAMPLE SETTINGS

LOW

VINTAGE

GCB95

SPECIFICATIONS

Impedance

Input 800 kΩ
Output 10 kΩ

Resonant Frequency

Heel Down 350 Hz - 450 Hz
Toe Down 1.5 kHz - 2.5 kHz

Maximum Level

Input -8.0 dBV
Output +10 dBV

Maximum Gain

Heel Down +19.5 dB
Toe Down +19.0 dB

Bypass True Hardwire

Noise Floor

Heel Down -98 dBV
Toe Down -89 dBV

Current Draw 900 µA

*A-weighted, OdBV = 1V

*

RMS