Dunlop CBM95 Users Manual

THE ORIGINAL SINCE 1967.

®

®

CBM95 CRY BABY

POWER

The Cry Baby® Mini Wah is powered by
one 9-volt battery (accessed via the bottom
of the pedal), an AC adapter such as the
Dunlop ECB003/ECB003EU, or a DC

™

power supply.

Brick

SETUP INSTRUCTIONS

• Run a shielded instrument cable

from your guitar to the CBM95’s
INSTRUMENT jack.

• Run another shielded instrument cable
from the CBM95’s AMPLIFIER jack into
your amplifier input.

• Turn on the

• To turn the pedal on/off, push the toe of

the pedal down until you feel a “click.”

and begin playing.

MINI WAH

• By rocking your foot back and forth
on the pedal, you can instantaneously
change the effect that the Cry Baby Wah
has on the tone of your instrument.

• Located under the rocker at the heel of
the pedal is an adjustable torque clutch.
Turn clockwise to increase resistance or
counterclockwise to decrease resistance
(Wrench included).

• Internal VOICING switch allows you
to change the frequency range of the
CBM95. To access, remove bottom
plate. Default setting is H—High, for
the standard GCB95 sound. For a more
vintage, midrange-focused sound, set
the switch to M. For a lower frequency
range, select L.

See Diagram A

DIAGRAM A

SAMPLE SETTINGS

LOW

VINTAGE

GCB95

SPECIFICATIONS

Impedance

Input 800 kΩ
Output 10 kΩ

Resonant Frequency

Heel Down 350 Hz - 450 Hz
Toe Down 1.5 kHz - 2.5 kHz

Maximum Level

Input -8.0 dBV
Output +10 dBV

Maximum Gain

Heel Down +19.5 dB
Toe Down +19.0 dB

Bypass True Hardwire

Noise Floor

Heel Down -98 dBV
Toe Down -89 dBV

Current Draw 900 µA

*A-weighted, OdBV = 1V

*

RMS