Dunlop 95Q Cry Baby User Manual

THE ORIGINAL SINCE 1967.
92503000500revF
95Q CRY BABY
®
WAH WAH
POWER
The 95Q Cry Baby® Wah Wah is powered by one 9-volt battery (accessed via the bottom of the pedal), an AC adapter such as the Dunlop ECB003/ ECB003E, or a DC Brick
power supply.
CONTROLS
• VOLUME knob controls amount of gain added by BOOST switch, up to 15dB
• VARIABLE Q knob adjusts frequency range of wah wah effect
• BOOST switch increases output as set by the VOLUME knob
• Silent “auto-off” switching puts pedal into bypass mode when you take your foot off
SETUP INSTRUCTIONS
• Run an instrument cable from your guitar to the 95Q’s Instrument jack and another instrument cable from the 95Q’s Amplifier jack into your amplifier’s input.
• The 95Q is bypassed (turned off
whenever your foot is off the pedal. To turn it on, simply press the toe of the pedal down with your foot.
• Set both the VOLUME control
and the VARIABLE Q control fully counterclockwise.
• Rotate the VARIABLE Q knob clockwise
for a narrower frequency range to emphasize higher end harmonics or counterclockwise for a wider frequency range that emphasizes lower end harmonics.
• To increase the 95Q’s output, engage the BOOST switch and rotate the VOLUME control clockwise to increase the amount of gain, up to 15dB, or counterclockwise to decrease it.
• Rock your foot back and forth on the pedal to hear the vocal, expressive tones that the Cry Baby is famous for.
ADJUSTABLE VOLUME control sets level of preset gain boost of up to +15dB
BOOST SWITCH kicks in the amount of boost set by VOLUME control
Silent “AUTO-OFF” switching
puts the pedal in BYPASS mode
when you lift your foot
VARIABLE Q control lets you adjust the frequency width of the effect
DUNLOP MANUFACTURING, INC.
P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL: 1-707-745-2722 FAX: 1-707-745-2658
SPECIFICATIONS
Impedance
Input 1 MΩ Output 1 kΩ
Noise Floor*
Heel Down -98 dBV Toe Down -90 dBV
Bypass Filter
Center Frequency 390 Hz to 2 kHz Maximum Gain 17 dB
Boost Range 0.1 dB to 15 dB Bypass Buffered Current Draw 1.8 mA Power Supply 9 volts DC
*A-weighted
Loading...