INSTRUCTION MANUAL
5
ELECTRIC PRINCIPLE DIAGRAM
Ⅴ
OPERATION OF REFRIGERATOR
-
The internal temperature of the thermoelectric refrigerator depends on the room temperature. The
refrigerator can be adjusted within the range of 11℃—18℃ (± 1°C), when it is located in an ideal room
temperature of 25℃.
-
When first switching on, without putting any bottles inside the refrigerator, the product can be cooled to 15℃
after 1.5 hours and after 2~2.5 hours more it will reach the temperature programmed by the manufacturer.
-
When turning the refrigerator on, the cooling system activates automatically.
-
When the power is connected, the cooling system starts to work.
-
The temp you want can be set by touching “ ” and “ ” with your finger. When the inside
temperature is higher than the set point, the cooling system starts working normally. When the inside
temperature is lower than the set point, the cooling system stops working, then it starts automatically again
when temperature rises above the set point. At this point, the refrigerator automatic conditions allowing a
constant control of temperature and energy saving cycle, in fact during this phase, the cooling system stops
while cold distribution (by fans) acts more slowly and promotes a larger energy saving.
-
The Light can be turned OFF or ON by touching the sensor button
“ ”
.If you forget to turn OFF
the light, it will turn off after 10 Min.
NOTE:
-
Shortly after you set the temperature, the LCD display will show the temperature levels that you have set in
the cooler. Once you have done this, the LCD display will show the actual temperature inside the
refrigerator, a value that will be change until it reaches the set temperature.