DU-HA 70102 Installation Instructions Manual
Part # 70102
Installation Instructions
DU-HA Replacement Subwoofer Box (with amp)
for 09-10 Ford F-150 Supercab
STEP
Materials Needed:
//
//
//
To remove Factory Subwoofer:
1
Lift up rear passenger seat.
Remove 4 bolts pictured using an 8mm socket.
2
Turn subwoofer box over and unplug wires going into silver amp.
3
Remove 4 screws from amp box using a phillips screwdriver, then remove amp.
4
5
Remove 8 screws from the speaker using a phillips screwdriver as pictured.
1
8mm Socket
Phillips Screwdriver
Needlenose Pliers
Fits DU-HA Part Numbers
20096
20071
20072
20073
1
2
3
Pull the speaker out of the box as far as possible. Apply light pressure up on the black
6
tab under the speaker, gently wiggle the metal plugs free from the speaker using a
needlenose pliers. Remove all 4 metal connectors from the speaker. Set speaker aside.
7
Pull cord that was originally plugged into the amp all the way out of the factory box.
Go to
8
“Step 2” of installation instructions.
5
6
7
Part # 70102
Installation Instructions
DU-HA Replacement Subwoofer Box (with amp)
for 09-10 Ford F-150 Supercab
STEP
Materials Needed:
//
//
//
//
//
//
To Install DU-HA Replacement Subwoofer Box:
1
Install amp on side of replacement subwoofer box in pre-drilled holes as pictured.
(Note: The amp plug should not go past the front of the box.)
2
Feed speaker wire (the end with the smaller connectors) through the hole on the
outside of DU-HA subwoofer box to the inside of box, leaving amp plug on the outside.
2
Phillips Screwdriver
Flat Screwdriver
Needlenose Pliers
Original Speaker
Original Amp
Original Wire/Plug
Fits DU-HA Part Numbers
20096
20071
20072
20073
1
3
4
Hook the connectors on the wires back to the speaker using a needlenose pliers.
3
(It doesn’t make a difference which side the connectors hook into.)
4
Set the speaker in the subwoofer box and insert all eight screws into pre-drilled holes
and tighten down as pictured.
5
Use at screwdriver to help insert plug into box as pictured.
Plug in amp plug to amp.
6
Install nished DU-HA replacement subwoofer box inside DU-HA storage unit under
7
back passenger seat of the truck. Pull Ford factory wire (on the oor on the
passenger’s side) over the back of the DU-HA and plug it into amp.
7
5
6
Loading...