DuBOIS DBF002 Instruction Manual

A
10 2
B
1
1
2
3
4
1
2
INSTRUCTION MANUAL DBF002
CONTROLS TO WIND UP TO MEASURE TIME
Crown
Hour hand
Minute hand
Stop second
Day | date
Permanent-Sekunde
CFW 99001-DD, self-winding watch mechanism
Totaliser hours
Totaliser minutes
Wind up watch mechanism by turning the crown.
Pull the crown to position
2. Make sure to set the
current time either in the morning or in the afternoon.
Push the crown to position
1. Set current day and
date. Then push the crown all the way to position 0 again.
Press button A once to start time measurement.
Press button A again to stop time measurement.
Read the measured time using the totalisers.
Press button B to zero all time measuring hands.
By moving your hands, the complex watch mechanism is wound up constantly. The watch will come to a stop after a maximum of 48 hours if it is taken off and is not worn. To wind it up again, please follow the instructions on the right.
TO SET TIME AND DATE
Do not set the date between 10 pm and 2.30 am.
WW W.DUBOISFILS.CH
CARE WARRANTY
Your watch was made most carefully by our watchmakers and according to the most stringent quality guidelines. In the unlikely event of a defect in manufacture or material, DuBois et ls offers a two-year warranty as of the date of purchase. Normal wear and tear as well as damage caused by improp­er care or use of the watch is not covered by this warranty. The warranty is valid once the warranty certicate is com­pleted at the time of purchase of the watch.
Please contact DuBois et ls directly in the event of damage and present the watch along with the completed warranty card.
To ensure excellent functioning of this watch for many years, neither expose the watch to impacts of any kind nor to strong sun light. Clean the housing with a microbre cloth. Clean the metal watchstraps and rubber watchstraps with a toothbrush and soap water. Use a soft cloth for drying. To preserve leather watchstraps, try to avoid contact with water or humidity and do not overly expose them to sun light. Leather is a permeable natural material that is sensitive to grease and make-up.
Like any other precision instrument, your watch needs to be inspected regularly to function properly over time. Make sure to have your watch inspected by a DuBois et ls watchmak­er every ve years.
WATER RESISTANCE
Natural wear of seals and accidental impacts to the crown can affect the water resistance of the watch. It is advised to check the watch for water resistance on a yearly basis by DuBois et ls. Do not actuate the buttons of the chrono­graph while under water to prevent water ingress into the watch mechanism.
Loading...