Dual Pumps Spray Wash SW2010PHR User Manual
spraywash215x75.pdf 1 21/08/2018 09:03:20
SW2010PHR Washer
User Manual
793-1206
Product id & serial number information
SW Series Washer User Manual
This manual and any other literature supplied should be read thoroughly before
assembling and operating the Washer. Pay particular attention to any instructions relating
to safety, and the starting, stopping and maintenance of the Washer. Following these
instructions will ensure operator safety and prolong the life of the Washer.
This manual should be kept for future reference as it contains important safety, user
and maintenance information. The model and serial number on the cover of this booklet
must be quoted should you need to contact the dealer or manufacturer regarding usage,
maintenance and warranty queries.
Recommended Safety Standards & Directives
This manual highlights certain safety measures which should be taken in to consideration
when using the Washer. However, each contractor and operator should make their
own risk assessments whilst considering their individual application and environment
and ensure the user is properly trained and wearing protective clothing to the required
regulatory standards. We recommend visiting the Health and Safety Executive website
at www.hse.gov.uk to be properly informed on best practice whilst operating Pressure
Washers in the UK.
Contents Page
1 Environmental Protection .......................................................................... 1
2. Safety Information ................................................................................... 1-2
3. Model Information ...................................................................................... 2
4. Component & Accessory Identification ..................................................... 3
5. Pre-Operation Set Up ................................................................................ 4
6. Start Up / Shut Down Procedure ............................................................... 5
7. Operating Information ............................................................................. 5-6
8. General Maintenance Information ............................................................. 6
9. Storage Information ................................................................................... 7
10. Troubleshooting ...................................................................................... 7-8
11. Warranty Information ..............................................................................8-9
12. EC Declaration of Conformity .................................................................. 10
1. Environmental Protection
Old appliances contain valuable materials
that can be recycled; these should be sent
for recycling. Batteries, oil, and similar
substances must not enter the environment.
Please dispose of your old appliances using
appropriate collection systems.
Please do not release engine oil, fuel oil,
diesel and petrol into the environment.
Protect the ground and dispose of used oil
in an environmentally-clean manner.
The packaging material
can be recycled. Please do
not throw the packaging
material into household
waste; please send it for
recycling.
2. Safety Information
Warning - Engines produce fumes and toxic gases.
!
Only operate outdoors or in a sufficiently well ventilated area.
Warning – Fuel vapours are flammable.
!
Allow unit to cool before refuelling at a safe distance from naked flames, ignition
sources & heat. Refer to engine manufacturer’s manual.
Warning – Washers can cause harm to people, animals &
!
property.
They should only be used by properly trained operators wearing suitable protective
eyewear, clothing, and non-slip footwear and in a safe, open environment.
Warning – Poorly maintained components can lead to
!
injury.
Before every period of use ensure the Washer is in good working order. All loose
connections should be tightened and worn or damaged components should be
replaced before use.
Warning – The Washer is performance set at factory.
!
Do not adjust the engine governor or Washer valves unless qualified to do so. Over
loading of engine and components can lead to equipment failure, personal injury
and will void the warranty.
1
Warning – Damage to Washer can occur if left running.
!
Do not leave the Washer running in bypass for extended periods as heat build-up
can damage the pump. Do not leave unit running unattended.
Warning – Never pump flammable or explosive liquids.
!
The Washer must only be used with liquids compatible with the pump, component &
accessories.
Warning – Chemicals can damage the pump and
!
components.
The Washer must be flushed through with clean water after every period of use as
chemicals and detergents can corrode the components.
THE MANUFACTURER CANNOT BE HELD RESPONSIBLE FOR ANY HARM
OR DAMAGE CAUSED BY DISREGARDING THE DESIGNATED USES OF
THIS MACHINE, ITS INSTRUCTIONS AND WARNINGS INDICATED IN THIS
BOOKLET.
3. Model Information
The SW2010PHR SW Series Washer has been designed and manufactured for the wash
down of machinery, vehicles, buildings, facades, tools etc using clean, soft water at a
maximum of 40°C and suitable detergents.
It should not be used for washing electrical equipment, people, animals and surfaces that
are loose and easily damaged.
Part No. Engine Drive
SW2010PHR
SPL = Sound Power Level on equipment representative for this type.
Petrol
GX120
GSPL = Guaranteed Sound Power Level for this equipment
Direct drive
via coupling
Bypass
Type
Return to
Tank
Lpm Bar
20 10 107 111
SPL LwA dBGSPL
LwA dB
2
Loading...