Dualit 72795, 72790 User Manual

Dualit Limited County Oak Way Crawley West Sussex RH11 7ST

t: [phone] f: [phone] e: [e-mail] www.dualit.com

IMPORTANT SAFETY PRECAUTIONS

OR BY POST

KETTLE

REGISTER YOUR

DON’T FORGET TO

TO REPLACE FUSE,
REMOVE SILVER LABEL

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE(S) SOLUTION(S)

THE KETTLE DOES NOT TURN ON

1. The kettle may not be properly connected to the power supply
or the fuse may have failed.

2. Boil dry feature may have been activated. If the kettle is accidentally switched on
with no water inside, the boil-dry device will switch off the heating element to
prevent damage to the kettle.

3. The element may have broken if the power neon illuminates but the kettle
does not boil.

4. The kettle does boil but the power neon does not illuminate. 4. The power neon may have blown. Call customer services on 01293 652500

THE KETTLE IS SPUTTERING OUT OF THE SPOUT

1. You may have over lled the kettle. 1.1 Only ll to the max mark (1.7L).

2. The kettle may have descaling solutions remaining inside the body. 2. Follow the instructions from the cleaning & care section and rinse throughly.

3. The lter may not be in position. 3. Ensure the lter is in position. For spare lters call Dualit on 01293 652500.

MY KETTLE IS NOT SWITCHING OFF

1. Limescale may have built up inside the kettle. 1. Descale your kettle regularly (see cleaning & care).

2. Check the lid is rmly closed during use. 2. Pips on inner lid rim can be pushed in to create a tighter t.

3. Water may have gone down the steam tube whilst lling. You may have overlled,
tilted the kettle when lling or lled through the spout.

MARKS HAVE APPEARED IN THE KETTLE

1. Small brown spots can build up inside the kettle. This is not rust, small deposits of
scale which contain iron can build up inside the kettle.

THE KETTLE LEAKS FROM THE LID

1. The lid seal may be damaged or have a build up of limescale. 1. Replace the seal. For spare seals call Dualit on 01293 652500.

WATER DROPLETS COLLECTS ON TOP THE POWER BASE

1. This is condensation and perfectly normal. 1. Dry with non abrasive cloth.

Patents: US5957723, AU2015200593, DE69701177, CN104825053 Pending Patents: GB2524872, GB150200.1 Design Reg: 002399337
Trademarks: WE923789, UK2416444

1. Check the plug is in the socket and the switch is turned on. Replace the
fuse if necessary.

2. Wait 10 minutes for the kettle to reset.

3. The element can be replaced. Call customer services on 01293 652500
for servicing information.

for servicing information.

1.2 Wait 10 seconds to allow the boiling water to settle before pouring.

3. Leave the kettle for 24 hours to fully dry.

1. Descale regularly (see cleaning & care).

TO ACCESS SCREW.

READ ALL INSTRUCTIONS

BEFORE USING THE KETTLE KEEP THESE
INSTRUCTIONS FOR FUTURE REFERENCE

• THIS IS AN ATTENDED APPLIANCE
D

o not leave appliance unattended during use,

unplug after each use (risk of re if an unattended

appliance is left operating or plugged in).

• This appliance must not be used by children younger than

DUALIT.COM/REGISTER

Instruction Manual

Classic Jug Kettle

GB-F

8 years old and persons with very extensive and complex
disabilities. Children aged 8-14 years and persons with reduced
physical, sensory or mental capabilities or lack of experience
and knowledge shall not use this appliance, unless they are
supervised and have been given instruction concerning the
use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children unless
they are older than 8 and supervised. Keep the appliance and
its cord out of reach of children less than 8 years old.

• This appliance is intended for household use only. If the

appliance is used improperly or for professional or semi­professional purposes or if it is not used according to these
instructions the Guarantee becomes invalid and Dualit refuses
any liability for damage caused.

Electrical safety

• Before plugging in, check that the voltage on the rating label is

the same as the mains supply.

• A short power-supply cord is to be provided to reduce risks

resulting from becoming entangled in or tripping over a longer cord.

• Do not operate any appliance with a damaged lead or plug,

or after the appliance malfunctions or has been damaged or
dropped in any manner.

• In order to avoid hazard, if the power cord is damaged

it must, for safety reasons, be replaced by Dualit or an
authorised Dualit repairer, call Dualit’s Customer Helpline on
[phone].

• NOTE: any plug cut from the power supply cord should be

disposed of immediately. Inserting any cut off plug into a 13A
socket-outlet is hazardous.

• Never use the plug without the fuse cover tted. Ensure

replacement fuse is the same current value as the original.
Replacement fuses are available and should be ASTA
approved to BS1362.

• To be protected against electrical hazards, re and injury to

persons, do not immerse the mains lead, plug, power base or
kettle in water or any other liquid.

• To disconnect, turn any control to off, then remove plug from

wall outlet.

• Unplug the power base from the wall socket when not in use,

or before moving and cleaning.

General safety

• NOTE: when you lift the kettle from the base, you will see

drops of moisture on the surface of the power base. This is
the steam used to switch the kettle off automatically, which
then condenses and escapes through vents in the underside of
the kettle. This is perfectly normal, and should not be cause for
alarm or returning the kettle.

• Do not operate the kettle unless the water lter is correctly in

position.

• Do not operate the kettle unless it contains at least 250ml of

water and the oor of the kettle is covered.

• Do not ll via the spout.

• Do not use if dropped, cracked or damaged.

• Do not use the kettle for any purpose other than heating water.

Otherwise, this may result in an injury caused by misuse.

• Do not place the kettle, power base or mains lead on or near any

hot surface, hot hob, gas burner or in a heated oven.

• Ensure that the kettle is correctly positioned on the power base

before switching on.

• Do not ll above the bottom of the ‘max’ mark on the water level

indicator.

• Do not operate the kettle on an inclined plane.

• Do not use in bathroom or outdoors.

• Remove the kettle from its power base before lling or pouring.

• Ensure that the lid is fully closed before switching the kettle on,

otherwise it may not properly switch off.

• Do not remove or open the lid while the water is boiling.

• Do not move the kettle while it is switched on.

• Use handles or knobs – do not touch hot surfaces.

• If the kettle is overlled, boiling water may be ejected.

• When boiling, hot steam will be emitted from the

kettle. Scalding may occur if you are within 400mm of
the spout.

• Ensure that the kettle spout is pointing away from any electrical

plug or socket.

• Scalding may occur if the lid is opened during the boiling cycle and

the body of the kettle will get hot.

• Take care when pouring – pour slowly and do not over-tilt the kettle.

• Water will remain hot for a considerable time after boiling and

can present a scald hazard. Keep the kettle, power base and the
mains lead away from the edge of worktops and out of the reach
of children.

• Avoid spillage on the connector.

• Use the kettle only with the power base supplied and vice versa.

• The use of accessory attachments not recommended by Dualit

may result in re, electric shock or injury to persons.

• This kettle features boil-dry protection. If the kettle is accidently

switched on without water, the boil-dry device will switch off
the heating element to prevent damage to the kettle. Wait
approximately 10 minutes for the kettle to cool down, lift and

rell as normal. The kettle is now ready to use again. NOTE: if

discolouration of the heating plates has occurred, this can be easily
removed by descaling your kettle.

• Allow the kettle to cool down completely before cleaning and storing.

• Do not store or use in an appliance garage or under cupboards.

• CAUTION: to prevent damage to the appliance, do not use

alkaline cleaning agents. When cleaning, use a soft cloth and a mild
detergent.

• Do not boil the kettle if lled with descaling solution.

• Do not use scouring pad or abrasive cleaner on the appliance body.

SAVE THESE INSTRUCTIONS

Unpack the box with care, keeping all the packaging materials until you are satised
everything is present and in working order. Once satised remove any tags from the

appliance body and recycle the packaging appropriately. Do not remove tags from the
cord. You may wish to keep the box to store your appliance.

KNOW YOUR CLASSIC JUG KETTLE

P

L

U

G

I

N

B

E

F

O

R

E

U

S

E

P

L

U

G

I

N

B

E

F

O

R

E

U

S

E

BOILING WATER

LID SEAL

SPOUT

WATER FILTER

VIEWING WINDOW

MAX MARK INDICATOR

POWER NEON

(RED)

POWER BASE

CORD TIDY

All illustrations are for representation only, your model may vary from illustrations shown. In the interest of improving products, Dualit Ltd.

reserves the right to change the product specication without prior notice.

HINGED LID

LID RING

LID PIP (3x)

SURE GRIP HANDLE

ON/OFF SWITCH

POWER CORD

SETTING UP

1

POSITION

Place the kettle as close to the wall
socket as possible. When in use ensure
the kettle is not placed under kitchen
cabinets. DO NOT STORE OR

USE YOUR KETTLE IN AN
APPLIANCE GARAGE OR
UNDER CUPBOARDS.

2

CORD TIDY

Use the shortest cord possible.
Wrap excess cord round the
cord tidy on the base of
the kettle.

3 4

INCLINED PLANE NOT IN A TRAY

Do not operate on an inclined
plane.

Do not operate in a tray.

FILLING YOUR KETTLE

E

F

B

O

N

R

I

G

U

1

TURN ON

Plug the kettle into the power socket. Press the

‘On/Off’ switch down. The power neon will

illuminate and the kettle will start to heat up.
If the kettle is accidentally switched on with no
water inside, the boil-dry device will switch off the
heating element to prevent damage to the kettle.

L

P

E

U

S

2

E

The kettle will automatically turn off after the
water has boiled.
To turn off before the water has boiled lift

the ‘On/Off’ switch up.

Always unplug the kettle after each use.

TURN OFF

N

E

N

H

W

G

U

L

P

N

U

CLEANING & CARE

N

E

N

H

W

G

1 3

THE BODY

Unplug and let the kettle cool down
completely before cleaning. Remove the
kettle from the power base.

Wipe the outside and inside surfaces of the
kettle with a damp cloth.

U

L

P

N

U

O

T

I

N

2

U

S

E

Unplug and let the kettle cool. Open the lid.

Hold the top of the lter, pull up and out of

the kettle. Rinse under a tap while carefully
brushing it with a soft brush.
Rinse the kettle out with fresh water.

DO NOT OPERATE KETTLE
UNLESS THE WATER FILTER IS
CORRECTLY IN POSITION.

WATER FILTER DESCALE REGULARLY

O

T

I

N

3

U

S

E

Remove kettle from the power base.
To avoid the risk of splashing, once the kettle
has boiled wait 10 seconds then pour slowly.
Do not over-tilt the kettle.

Use descaling products suitable for kitchen
appliances, these are readily available online
or from most supermarkets or department
stores. Use as per instructions on the packet.

Follow these few simple steps to minimise
scale build up in your kettle: Empty the kettle
after each use; do not allow water to stand in

the kettle overnight. Use ltered water instead

of tap water. Descale the kettle regularly, at
least once a month. If you live in a hard water
area you may need to descale more often.

When descaling has nished, empty the

kettle and rinse it out a minimum of 3 times

with fresh water, then rell with fresh water,

boil, then discard boiled water. FAILURE
TO DO SO CAN CAUSE INJURY.
DO NOT BOIL KETTLE WITH
DESCALING SOLUTION IN IT.

POURING

WARNING: IF THE KETTLE HAS JUST BOILED, IT WILL BE FULL OF STEAM, WHICH WILL ESCAPE AS SOON AS
THE LID IS OPENED. THE LID WILL BE HOT. USE THE LID RING TO OPEN AND CLOSE THE LID.

OPEN LID

1

Ensure the kettle is unplugged. Remove the
kettle from the power base. Gently pull the lid
ring up and back to open the lid.

Tip: If the lid is too tight, try pushing in the
pips on the inside of the lid with a spoon
handle. Pushing the lid pips back out will give

a tighter t. WARNING: IF THE LID IS
TOO LOOSE, RISK OF SCALDING.

LID TIGHTNESS

2

FILLING

3

Fill the kettle through the lid opening. Use at
least one cup of water (250ml). The water level

must stay below the ‘max’ mark. Save energy,

only boil what you require. Keep kettle upright

and level at all times when lling. Do not tilt

kettle backwards. DO NOT OVERFILL OR
FILL THROUGH THE SPOUT.

Push the lid down using the lid ring to close.

KETTLE REPAIR

Core components of your kettle are replaceable!

The Classic Kettle has been built to last, but should you experience any fault with your kettle, please contact Dualit for advice. The

Classic Kettle is repairable and tted with a patented, repairable element. Simply contact our helpline on 01293 652 500 or visit www.

dualit.com/support for repair or servicing advice.

All servicing must be carried out by Dualit or authorised repair agent.

For your own protection only use original Dualit spares in your kettle. Fitting of non Dualit parts will invalidate the guarantee.

INSTRUCTIONS ON ENVIRONMENT PROTECTION

Do not dispose of this product in the usual household garbage at the end of its life cycle. Please hand
it over to a collection point for the recycling of electrical and electronic appliances. The symbol on the
product, the instruction of use or the packaging will inform you about the methods of disposal. The
materials are recyclable as mentioned on its marking. By recycling, material recycling or other forms of
re-utilization of old appliances you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorised disposal location.