Dualit 72022 Guarantee And Instructions

• Make sure that your hands are clean

and free from hand cream, soap or

similar, which might leave a slight

taint to the water.

• Remove the kettle from the power

base and ensure kettle is cold.

• Open the lid. Hold the top of the

filter and pull it gentle up and out

of the kettle. Rinse it under a tap

whilst softly brushing it with a soft

brush. Rinse the kettle out with

fresh water.

• To replace, align the sides of the filter

with the grooves in the filter holder,

and slide it slowly downwards and

back into place.

AAFFTTEERR SSAALLEESS SSEERRVVIICCEE

If the kettle is not working correctly,
check that:

• You have followed the
instructions correctly.

• The plug fuse has not blown.

• The main supply fuse/circuit breaker
has not blown/tripped.

If the powercord is damaged it must

be replaced by a special cord set

CCAARREE AANNDD CCLLEEAANNIINNGG

• Switch the kettle off (lift it from the
power base), unplug the power base
from the wall socket, and let the
kettle cool down completely before
cleaning. Wipe the outside and nside
surfaces of the kettle with a damp
cloth.

• If necessary, you may use a little
household detergent. To clean the
filter, see “Water filter” below.

• If you use detergent inside the kettle,
rinse thoroughly afterwards to
remove all traces.

• Ensure that all connectors and
sockets are kept dry.

• Do not immerse the kettle or power
base in water or any other liquid.

• Do not use harsh or abrasive cleaners
or solvents.

DDeessccaalliinngg

• Scale build-up will cause the element
to overheat, reducing its working
life. It may also cause the safety
cutout to operate prematurely,
switching the kettle off before the
water actually boils.

• As the kettle uses an under floor type
element, lime scale can only build up
on the walls and floor of the kettle,
this is readily seen and should be
promptly dealt with.

available from Dualit or an authorised

Dualit service agent.

This part should only be refitted

by a competent electrician.

If it still does not work, telephone the

Dualit Customer Helpline on:

+ 44 (0) 1293 652 500 or the shop

where you bought it.

GGUUAARRAANNTTEEEE

If your Kettle fails within one year
from date of purchase. we will repair
or replace it free of charge provided:

• You have not misused, neglected

or damaged it.

• It has not been modified.

• You supply your receipt to show

when you bought your toaster.

The guarantee does not affect your
statutory rights.

If over one year contact Dualit for
recommended repair agents.

Contact the Dualit Customer Care
Line on

++4444

(0) 1293 652 500

(09:00 to 17:00 Monday to Friday)

or, alternatively email your enquiry
to [e-mail].

GUARANTEE AND
I NSTRUCTIONS

FOR

D UALIT

J UG K ETTLE

DUALIT LIMITED COUNTY OAK WAY CRAWLEY WEST SUSSEX RH11 7ST

TELEPHONE: +44 (0)

1293 652 500

FACSIMILE: [phone]

EMAIL: [e-mail] WEB: www.dualit.com

Safeguards

1

Before Use

2

Care And Cleaning

3

5

How To Use

4

6

Guarantee

After Sales Service

MMiinniimmiissee SSccaallee BBuuiilldd--uupp

• Empty the kettle after each use; do
not allow water to stand in the kettle
overnight; use filtered water instead of
tap water.

• Descale the kettle regularly, at least
once a month, using a proprietary
brand of descaler. In areas of very
hard water descaling may be
necessary more often.

• When descaling, follow the
instructions on the packet of the
descaler. When descaling has finished,
empty the kettle and rinse it out
numerous times with fresh water, then
refill with freshwater, boil, and discard
boiled water.

WWaatteerr FFiilltteerr

Depending upon the hardness of the
water the scale particles that remain
suspended in the water may give a
cloudy appearance. The filter fitted to
your kettle will prevent these particles
passing into your drink. You therefore
must ensure that the filter is kept clean
and clear of deposits, otherwise the
performance of your kettle may be
affected, your drinks may contain scale
and the water inside the kettle may look
cloudy.

• You should clean the filter whenever
there are any obvious deposits left on
the mesh and especially if pouring is
affected.

CE Compliant to
89/336/EEC (EMC directive) and
73/23 & 93/68/ EEC (LV directive)

5

4

6

14 12 05 Jug kettle with image quark file.qxp 15/12/2005 10:45 Page 1

HOW TO USE

• Position the power base as close to a
wall socket as possible. Locate the
mains cable so that it does not
overhang the work surface, and
cannot be caught accidentally.
Shorten the mains lead by winding it
around the cord storage area under
the power base, and bring it out of
the cord exit in the base.

OOppeenniinngg TThhee LLiidd

• Remove the kettle from the power
base. If the switch has been pushed
down inadvertently, it will spring up,
into the “Off” position.

• Hold the kettle handle firmly in one
hand, hold the lid knob in the other,
and pull the lid straight up. As soon as
it separates from the kettle, move it
out of the rising steam.

FFiilllliinngg

• Open the lid and fill the kettle
via the lid aperture. Not through
the spout.

• Observe water level when filling, you
must use at least one cup of water,
but the water level must be below the
Max mark.

• Do not overfill the kettle. If the
kettle is overfilled, there is a risk that
boiling water may be ejected from
the spout and lid.

• Replace the lid and ensure it is

firmly in place. Check that it is fully

closed, otherwise the kettlemay not

switch off when boiling.

appliance malfunctions, or has been
damaged in any manner.
If the mains lead is damaged,
it must be replaced by a special
cordset available from Dualit helpline:
+ 44 (0) 1293 652 500

BBEEFFOORREE UUSSEE

• Remove all packaging from the kettle
and its power base. Before using the
kettle for the first time, or if it has
been out of use for a long time,
fill to the max mark and boil, then
discard the boiled water and rinse the
kettle out with fresh cold water.

CCoonnnneeccttiioonn TToo TThhee MMaaiinnss SSuuppppllyy

• Check that the voltage marked on
the appliance corresponds with the
supply voltage.

• NOTE: Any plug cut from power
supply cord should be disposed
of immediately. Inserting any cut
off plug into a 13A socket-outlet
is hazardous.

33

• Never use the plug without the
fuse cover fitted. Ensure replacement
fuse is the same current value
as original.

• Replacement fuses are available from
Dualit and should be ASTA approved
to BS 1362.

• When filling or carrying the kettle, do

not tilt it backwards, as this may allow

water to pass through the steam tube

onto the control area. Should this

happen, the kettle must be allowed to

dry before reuse.

• To avoid the risk of splashing, pour

sslloowwllyy

and do not over-tilt the kettle.

WWAARR NNIINNGG::

IF THE KETTLE HAS JUST

BOILED, IT WILL BE FULL OF STEAM,

WHICH WILL ESCAPE AS SOON AS

THE LID IS OPENED.

BBooiill DDrryy

• Do not switch the kettle on unless it

contains at least one cup of water.

Misuse of this kind will shorten the

life of the kettle.

• If the kettle is accidentally switched

on when it does not contain sufficient

water, a boil-dry device will

automatically switch it off. Wait until

the kettle has cooled down before

refilling. The lid may be hot and the

water may spit as it touches the kettle

base.

SSwwiittcchhiinngg OOnn

• Check that the switch is in the

“Off” position (lift the kettle

from the power base and set it

down again taking care not to

spill any water). The switch will

only operate when the kettle is

correctly fitted onto the base.

• Plug the power base into the wall

socket. If necessary, switch on the

wall socket.

• Press the switch down. The neon

light will light up and the kettle

will start to heat up.

• When the water has boiled the

kettle will automatically switch off,

the switch will return to the “Off”

position and the neon light will

go out.

NOTE: When you lift the kettle
from the base, you
will see drops of moisture
on the surface of the power
base. This is the steam used to
switch the kettle off
automatically, which then
condenses and escapes via
vents in the underside of the
kettle. This is perfectly normal,
and should not be cause for
alarm or returning the kettle.

• Remove the kettle from the power

base before pouring.

• Do not allow the mains lead to hang
over the edge of the worktop, or
anywhere it may accidentally be caught
or tripped over.

• Close supervision is necessary when
any appliance is used near children.

• Do not leave appliance unattended
when in use.

• This appliance is not intended for use
by young children or infirm persons
without supervision.

• This kettle is for household use only.

• Unplug the power base from the wall
socket when not in use,
before moving and cleaning.
Allow the kettle to completely cool
down before cleaning and storing.

• Ensure that the lid is fully closed before
switching the kettle on, otherwise it
may not properly switch off.

• Ensure that the kettle is correctly
placed onto the power base before
switching on.

• Do not fill above the bottom of the
max mark on the water level indicator.
Remove the kettle from its power base
before filling or pouring.

• Do not place the kettle, power base,
or mains lead on or near any hot
surface, hot hob or gas burners.

• Do not use the kettle for any purpose
other than heating water.

• Use the kettle only with the power
base supplied and vice versa.

• Do not operate any appliance with a
damaged lead or plug, or after the

Please read these instructions before
using your kettle, keep them in a safe
place for future reference.
Carefully remove all packaging before
use but keep the packaging until you
are satisfied that the kettle is working
correctly.

When using any electrical appliances,
basic safety precautions should always
be followed, including the following:

• To be protected against electrical
hazards do not immerse the mains
lead, plug, power base, or kettle in
water or any other liquid.

• Do not use in a bathroom or
outdoors.

• Use handles or knobs do not touch
hot surfaces.

• Do not open the lid when the water
is boiling.

• Take care when pouring – pour
slowly, and do not over-tilt the kettle.

• Water will remain hot for a
considerable time after boiling and
can present a scald hazard. Keep
the kettle, power base and the
mains lead away from the edge of
worktops and out the reach of
children.

• Do not switch on unless the kettle
contains at least 1 cupful of water.

READ ALL
INSTRUCTIONS

IMPORTANT
SAFEGUARDS

SAVE THESE
INSTRUCTIONS

1

2

3

14 12 05 Jug kettle with image quark file.qxp 15/12/2005 10:45 Page 2