Dual IPLUG XDMR7710 Installation & Owner's Manual

INSTALLATION/OWNER’S MANUAL

XM Ready Multimedia Receiver with Detach Face

XDMR7710

An optional XM Satellite Radio Receiver may be connected to the XDMR7710.

XM subscription is required for reception. For more information, visit XM’s website

at www.xmradio.com or call 1-877-XM-RADIO. Not available in Alaska or Hawaii.

2

TYPICAL FRONT-LOAD DIN MOUNTING METHOD

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for instructions.

• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Remove trim ring from unit,

• Remove 2 transit screws located
on top of the unit.

• Insert the supplied keys into the
slots as shown, and slide the unit
out of the mounting sleeve.

• Install mounting sleeve into
opening, bending tabs to secure.

• Connect wiring harness and
antenna. Consult a qualified
technician if you are unsure.

• Certain vehicles may require an
installation kit and/or wiring
harness adapter (sold separately).

• Test for correct operation and slide
into mounting sleeve to secure.

• Snap trim ring into place.

• Mount the iplug™ adapter to any
smooth clean surface using the
supplied double-sided tape or #2 x
3/8” Phillips head screws.

XDMR7710 INSTALLATION

Preparation

3

FUSE

When replacing the fuse,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XDMR7710 uses one
10 amp ATM fuse located
beside the wiring connector.

XDMR7710 INSTALLATION

Wiring Diagram

4

EQ

Mode/Search

Display

Preset #2/Random

Preset #1/

Repeat

Open

Volume

Eject

Preset #6/

Menu

*Key/Preset #7/Return

Tune/Track Down

Folder Up

AS/PS/Enter/Function

Tune/Track Up

1

2

3

4

5

6

7

8

9

10

Folder Down

*Key/Preset #8/Tuner Scan

*Key/Preset #9

*Key #0/Preset #10

Band/Play/Pause/Scroll

Infrared Se

nsor

Power

Preset #5

Preset #4

Preset #3/Intro

Reset

Audio/Setup

Record

14

15

16

17

18

19

20

21

22

23

24

19

1 2

5

6

4

25

*Function keys 7, 8, 9 and 0 apply to XM Radio and MP3/WMA operation only.

XDMR7710 OPERATION

Control Locations - Receiver

17

14

1516

8 9 107

232122

18

20

11

12

13

3 11 12 13

24

25

26

26

27

27

5

XDMR7710 OPERATION

Control Locations - Remote

*Key/Preset #9

*Key/Preset #8/Tuner Scan

*Key/Preset #7/Return

Preset #5

Preset #4

Preset #1/Repeat

Mode/Search

Tune/Track Down

Band/Play/Pause/Scroll

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

1

2

4

3

6

5

8

17

9

10

11

12

14

13

15

16

7

18

19

Power

Volume Up

AS/PS/Enter/Function

Audio/Setup

Tune/Track Up

*Key #0/Preset #10

Volume Down

Preset #3/Intro

Preset #2/Random

Preset #6/

Menu

6

The front panel is semi-permanently attached during
assembly. Please refer to the separate yellow instructions
(before installation) to make the front panel removable.

With the unit off, press

OPEN to allow the front panel to slide

down. Gently squeeze the release tab located on the bottom
center underside and pull front panel down and away from
unit to remove. To install, insert left side first, then push right
side to secure.

Press POWER or any other button (except EJECT or OPEN)
to turn the unit on. Inserting a disc will turn the unit on
automatically. Press

POWER to turn the unit off.

Press MODE to select between AM/FM, *XM Radio, CD
player and auxiliary input. Modes of operation are indicated
in the display.

*Optional XM Satellite Radio Receiver and

subscription required for XM Radio operation.

Adjust volume using rotary encoder (00-46).

Press and hold

POWER for 3 seconds to program currently

selected volume level. "P-VOL" and the current volume level
will momentarily appear in the display.

Press EQ to select between POP, JAZZ, CLASSIC, BEAT,
ROCK and OFF (default) equalization curves. Any adjustment
to the Bass or Treble settings automatically cancels the
current EQ curve (if one is selected).

When in AM/FM, CD or AUX mode:
Press DISP to select between clock and radio frequency
(tuner mode), clock and CD elapsed time/track (CD mode), or
clock and AUX (AUX mode).

When in XM Radio mode:
Press DISP to select between channel name, artist name,
song title or clock.

With the unit on, press and hold

DISP until the clock begins to

flash, then release. Press

TUNE

nn

to adjust the hours and

TUNE

ll

to adjust the minutes. Press DISP momentarily to

save the selected time.

Front Panel Note:

Front Panel Removal

Power On/Off

Mode

Volume

Programmable

Turn-On Volume

Preset EQ Curves

Display

Set the Clock

XDMR7710 OPERATION

General Operation

7

XDMR7710 OPERATION

General Operation - Setup Menu

Menu Function Options Action

Loudness Curve

LOUD OFF Disables the loudness function.
LOUD ON Enables the loudness function. Activating this feature

will enhance the bass and treble frequencies when
listening to music at low volumes.

Clock Display
Priority

FUNC PRI Radio frequency (tuner mode), XM information (XM

mode), CD elapsed time/track or MP3/WMA file
information (CD mode) or AUX (AUX mode) will be
displayed by default.

Clock is accessed by pressing

DISP momentarily.

CLK PRI Clock will be displayed by default. Radio frequency

(tuner mode), XM information (XM mode), CD elapsed
time/track or MP3/WMA file information (CD mode) is
accessed by pressing

DISP momentarily.

Tuner Frequency
Spacing

FREQ USA Programs the unit to USA tuner spacing.

(200kHz for FM and 10kHz for AM)

FREQ EUR Programs the unit to European tuner spacing.

(50kHz for FM and 9kHz for AM)

Clock Display

CLK OFF Programs the unit to not display the clock when the

power is off.

CLK ON Programs the unit to display the clock when the power

is off.

Auxiliary Mode

AUX ON Enables access to auxiliary mode.
AUX OFF

Disables access to auxiliary mode.

Beep
Confirmation

BEEP OFF Disables the confirmation beep.
BEEP ON Enables the confirmation beep.

Local/Distance
Tuning

LOC OFF Activates Distance tuning.
LOC ON Activates Local tuning for strong station reception only.

12/24-hour Clock

Setup Menu

The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10

:

00). In European frequency spacing

mode, the clock will display 24-hour time (22:00).

Press and hold

SETUP for more than 3 seconds to access

the setup m

enu. Press SETUP momentarily to select

between the menu functions and rotate the rotary encoder
left/right to adjust or activate the desired function.

8

Press AUDIO momentarily to select between Volume
(default), Bass, Treble, Balance, & Fader.

Press AUDIO until BAS appears then rotate encoder
left/right to adjust ( -6 minimum / +6 maximum).

Press AUDIO until TRE appears then rotate encoder
left/right to adjust ( -6 minimum / +6 maximum).

Press AUDIO until BAL appears then rotate encoder
left/right to adjust

(BAL L 12-BAL 00-BAL R 12).

BAL 00 represents equal balance

Press AUDIO until FAD appears then rotate encoder
left/right to adjust (FAD F 12-FAD 00-FAD R 12).
FAD 00 represents equal fader

Individual Bass and Treble settings are retained in memory
for AM, FM, CD, XM, and AUX modes. This allows you to
save the Bass and Treble settings separately for each mode.

Note:
Any adjustment to the Bass or Treble settings automatically
cancels the current EQ curve (if one is selected).

Press RESET upon initial installation or if abnormal
operation occurs. Refer to page 4 for the reset button
location.

This feature is available when used with the EAUSB20
Media Link Adapter (sold separately).

This feature is available when used with the EAUSB20
Media Link Adapter (sold separately).

This feature is available when used with the EAUSB20
Media Link Adapter (sold separately).

Audio

Bass

Treble

Balance

Fader

Source Audio Memory

Reset

Record

Menu

Return

XDMR7710 OPERATION

General Operation

BASSVOLUME

TREBLE BALANCE F

ADER