DSPPA P.A.SERIES MP 1600, P.A.SERIES MP 2100, P.A.SERIES MP 2600 Owner's Manual
1
P.A.SERIES
Public Address Amplifiers
MP 1600
MP 2100
MP 2600
Before operating, please read this manual completely!
FEATURES
z Transformer isolated 100V, 70V and 4 Ohms speaker outputs.
z 5 LED indicator for status display.
z XLR socket and 6.3 mm jack for link convenient.
z Output circuit shorting protection & display.
z Series amplifiers of high output power available.
OWNER’S MANUAL
2
Left blank for memo
3
AMPLIFIER FRONT VIEW
1. AC power switch
2. POWER LED indicator
3. CLIP LED indicator (Please reduce
the gain to prevent severely clipped
waveforms reaching the loudspeakers)
4. SIGNAL LED indicator (Output level)
5. PROT LED indicator (DC or
output circuit shorted indicator)
6. TEMP LED indicator
(high temperature indicator)
7. Volume (input attenuator)
8. Unit’s fan exhaust window
AMPLIFIER REAR VIEW
1. fan intake window
2. AC( low voltage ) fuse
3. 100V output
4. 70V output
5. 4～16Ω output
6. COM. output
7. 220V AC fuse
8. XLR input
9. 6.3mm socket input
10. 6.3mm socket link
11. XLR link
12. 220V AC power cord
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7
8 9 10 11 12
4
CONNECTING
CONNECTING INPUTS：Input connections
are made via either the 3-pin XLR-type connectors
(Figure 1) or 6.3 mm sockets on the rear side of
the amplifier.
CONNECTING OUTPUTS ：Load can be connected using banana plugs or spade lugs. A black
binding post is considered “COM”, while the three red binding posts are considered “hot”, and the
voltage is about 38V（different from the model）, 70V, and 100V.
Note:
Never connect the“hot”terminals together.
When connecting load（speakers）, it is better to use one pair of output terminals only.
If the PROT Led goes on steadily while power has been turned on and signal has been fed, there
must be a trouble of output shorted. Please turn the unit off and correct the trouble then turn it
on again.
ground signal
1
2
3
Figure 1 3-pin XLR-type connectors
Pre-amp.
MP-9911P
Another Amp.
MP-series
or
o
r
Loading...