DSP VHF/UHF FM transceiver User Manual

UV-5R.com

First Thing... charge your battery. Unlike some brands, Baofeng does not pre-charge the battery.
Programming Software... http://wouxun.us/Software/Baofeng/UV-5R Setup Files.zip
UV-5R Yahoo User-Group... http://groups.yahoo.com/group/baofeng_uv5r
Programming Manually... This is not covered in the owners manual, here’s how.

To program repeater 146.985, minus offset, 100 Hz tone, low power level, into Channel #010

Turn on radio.
If in Memory Mode switch to VFO Mode (VFO/MR)
Select 5 KHz Step - (MENU + 1 + MENU) (Use the   key for 5K) (MENU + EXIT)

Enter 146.985 The receive frequency
Press [MENU] + 2 + [MENU] Use the   key to select Low Power
Press [MENU] + [EXIT] To accept and exit
Press [MENU] + 5 + [MENU] Use the   key to select Wide Bandwidth
Press [MENU] + [EXIT] To accept and exit
Press [MENU] + 1 + 3 + [MENU] Use the   key to select 100 Hz Tone
Press [MENU] + [EXIT] To accept and exit
Press [MENU] + 2 + 7 + [MENU] Enter 010 or Use the   key to select 010
Press [MENU] + [EXIT] This stores the Receive Frequency

Radio prompts that REC FREQ has been stored
Enter 146.385 The transmit frequency
Press [MENU] + 2 + 7 +
[MENU] + [MENU] + [EXIT] Radio prompts that TX FREQ has been stored

Return to Memory Mode (VFO/MR)

UV-5R.com