Drummond Hood Mate Pipet-Aid 300 Installation & Operation Manual

Drummond Scientific
Company
Installation & Operation
Manual for Model 300
Catalog Number 4-000-300
Hood Mate
®
®
This equipment is for indoor use only.
(Maximum temperature 35°C, Maximum Humidity 60%)
Specifications
Rating 120 Volts, 60 Hz AC
Installation Category II
Pollution Degree One Input 6.3 VA Pipet Capacity Any pipet with a mouth
piece diameter 3 mm to
10 mm Maximum Fill Rate 10 mL/sec
CAUTION: CAREFULLY READ THROUGH THIS ENTIRE
MANUAL BEFORE USING YOUR NEW PIPET-AID. PAY CLOSE ATTENTION TO THE RULES FOR SAFE OPERATION WARNINGS AND CAUTIONS.
Made in USA
By
500 Parkway, Broomall, PA 19008 800/523-7480 • 610/353-0200 • FAX: 610/353-6204 www.drummondsci.com • www.pipet-aid.com
INSTALLATION
AAppppllyyiinngg tthhee MMoouunnttiinngg BBrraacckkeett
Determine a suitable area to place the mounting bracket and clean the surface with isopropyl alcohol. On the back of the mounting bracket there are three adhesive strips, pull the black removal tabs off these strips and press the mounting bracket firmly in place for thirty (30) seconds.
RReemmoovviinngg tthhee MMoouunnttiinngg BBrraacckkeett
To remove the mounting bracket from the inside of the hood, gently pull the removal tabs straight down until the bracket releases from inside the hood.
Press Here
FF iigguurree 22
This Side to Hood
Mounting Bracket
Adhesive
Tape
Hood Mate
®
Body
Holster
Power
Supply
Coiled
Hose
Pipet-Aid
®
Handle
Hook
FF iigguurree 11
Loading...
+ 5 hidden pages